Installation Guide

Installing Your Water Optimizer
Installing Your Water Optimizer 2-37
Diagram 2.6.3-A - Screw Compression To Quick Connect Adapter Onto Port or Hose
acc.
1x
For 1 Accessory Appliance Congurations, you will need to run a section of
A
1/4 in. White PP Tubing from your Accessory Appliance, directly to where
you plan to locate your Water Optimizer (unless the appliance alread has an integrated
Quick Connect Tubing hose you plan to use instead). Finish by connecting the
other
C
1/4 in. Quick Connect Shuto Valve to the end of the tubing or hose
that will connect to your Optimizer. It should look like this:
acc.
1x
HOSE/PORT > ADAPTER (if necessary) > TUBING (if necessary) >
SHUTOFF VALVE (where Water Optimizer will be located)
Once you’ve completed this, jump ahead to “Connecting Water Optimizer” on page
2-43.
If your Accessory Appliance’s port or hose is Female Compression, use
D
1/4 in. Brass Compression Union to adapt the port/hose to the
1/4 in. White PP Tubing line (referenced above). Instructions for this are including in
the following step and “Diagram 2.6.4-B” on page 2-39.
Extending
If your appliance has a port (rather than a hose), or a hose that will not reach suciently
far, follow the relevant directions below.