Use and Care Guide

Maintaining Your Water Optimizer 15

Maintaining Your Water Optimizer

Storing & Relocating Your Water Optimizer

At some point, you may need to store or relocate your Water Optimizer. Should one of

these situations be the case for you, below are a few simple steps to prevent any damage

from occurring.

1. First, if the cooling and/or heating systems are powered on, ip

Hot Mode Power Switch and

Cold Mode Power Switch into the down position

to power o. This should always be done prior to shutting o water supply.

2. Shuto water ow to your appliance by turning the blue handle on the

1/4 in. Quick Connect Shuto Valve (see Installation Guide) connected to your

Optimizer’s

Source Input Port located at the back of the appliance.

3. Grab a container (preferably with high sides) , like a bucket or pitcher, and place it on

the oor in front of your Water Optimizer.

4. Rotate your Optimizer counter-clockwise 90 degrees and slide forward towards

the edge of your counter-top (or whatever surface it is resting on) until roughly

30% of your Optimizer’s left side is extending over the edge. This will expose

Appliance Drain Port. Be sure to keep it braced with your body so it does not fall!

5. Ensure your container is directly below the

Appliance Drain Port.