Use and Care Manual

• The LP tank used with your grill must meet the following
requirements:
• Use LP tank only with these required measurements: 12"
(30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.)
Capacity maximum.
• LP tank must be constructed and marked in accordance with
specifications for the LP tank of the U.S. Department of
Transportation (DOT) or for Canada, CAN/ CSA-B339, tanks,
spheres and tubes for transportation of dangerous goods.
Transport Canada (TC). See LP tank collar for marking.
• LP tank valve must have:
• The LP tank must be arranged for vapor withdrawal and
include collar to protect LP tank valve. Always keep the LP
tanks in an upright position during use, transit or storage.
• Type 1 outlet compatible
with regulator or grill.
• Safety relief valve.
• UL listed Overfill Protection
Device (OPD). This OPD safety
feature is identified by a unique
triangular hand wheel.
Only use
the LP tanks equipped with this type of valve.
5
USE AND CARE
• NEVER store a spare LP tank under or near the
appliance or in an enclosed area.
DANGER
• Never fill a tank beyond 80% full.
• If the information in the two points above is not
followed exactly, a fire causing death or serious
injury may occur.
• An overfilled or improperly stored tank is a
hazard due to possible gas release from the
safety relief valve. This could cause an intense
fire with risk of property damage, serious injury
or death.
• If you see, smell or hear gas escaping,
immediately get away from the LP tank and
appliance and call your fire department.
LP Tank
LP Tank Removal, Transport and Storage
• Turn OFF all control knobs and the LP tank valve. Turn
coupling nut counterclockwise by hand only - do not use
tools to disconnect. Lift LP tank retainer strap upward off the
LP tank collar, then lift the LP tank up and off of the support
bracket. Install the safety cap onto the LP tank valve.
Always use cap and strap supplied with the valve.
Failure to use the safety cap as directed may result in
serious personal injury and/or property damage.
• A disconnected LP tank in storage or a LP tank being
transported must have a safety cap installed (as shown).
Do not store a LP tank in an enclosed spaces such as a
carport, garage, porch, covered patio or other buildings.
Never leave a LP tank inside a vehicle which may become
overheated by the sun.
• Do not store a LP tank in an area where children play.
LP Tank Valve
Safety Cap
Retainer Strap
OPD Hand Wheel
LP (Liquefied Petroleum Gas)
• LP gas is nontoxic, odorless and colorless when produced.
For Your Safety, LP gas has been given an odor (similar to
rotten cabbage) so that it can be smelled.
• LP gas is highly flammable and may ignite unexpectedly when
mixed with air.
LP Tank Filling
• Use only licensed and experienced dealers.
• LP dealer must purge new tank before filling.
• Dealer should NEVER fill the LP tank more than 80% of LP tank
volume. Volume of propane in tank will vary by temperature.
• A frosty regulator indicates gas overfill. Immediately close the
LP tank valve and call your local LP gas dealer for assistance.
• Do not release the liquid propane (LP) gas into the
atmosphere. This is a hazardous practice.
• To remove gas from the LP tank, contact a LP dealer or call a
local fire department for assistance. Check the telephone
directory under “Gas Companies” for your nearest certified LP
dealers.
LP tank in the upright position for vapor withdrawal