Owners manual

24 •34611-40100219

Side burner

□ Loosen side burner in side shelf. (B ). To loosen, unscrew and remove two front screws and washers

holding sideburner in place. (A). Note: Do not loosen electrode screw.

□ Remove the 2 pre-installed screws from the valve stem and set them aside. (C)

□ Insert valve stem through hole in fascia. (D). Install previously removed 2 screws .Note:Do not tighten

these 2 screws until the bezel is attached to fascia and valve face.(E).

□

Attach bezel to facial and valve face with the installed screws .Firstly attach one side key hole of

bezel to the screw ,then attach the other one to the other screw.Make sure the black mark facing

up.(F).Tightenthe2screws.(G)

□ Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (H)

□ Push control knob onto sideburner valve stem. (I)

□ Reattach sideburner to sideburner shelf with the 2 previously removed screws. Replace sideburner

grate. (J)

□ Connect both igniter wires to the igniter module on the i nside of the right fascia. To connect, push

igniter wire tips onto pins in igniter module.(K)

□

Unscrew igniter cap from control panel. Insert (1) AAA battery (provided in blister pack) into battery

slot with positive end (+) facing outward. Screw igniter cap back onto panel. (L)