Water Heater User Manual

Installation Instructions (cont'd)

Installation Checklist

• Whether or not the element conversion is made, the model

rating plate must be marked• Using a hard point ink pen,

check the appropriate block within the model rating plate,

which is located adjacent to the lower access panel.

• Is the fuse or circuit breaker size correct as shown in the chart

in the "Product Specifications" section?

• Are the wires from the circuit breaker or fuse service to the

water heater's junction box on the correct wire size (gauge) as

shown in the chart in the "Product Specifications" section?

• Is the new temperature-pressure relief valve properly

installed, and piped to an adequate drain? See "Temperature-

Pressure Relief Valve section.

• Is the water heater completely filled with water? See "Filling

the Water Heater" instructions in the "Installation

Instructions" section.

• Will a water leak damage anything? See "Facts to Consider

About the Location" section.

• Are the cold and hot water lines connected to the water heater

correctly? See "Water Piping" instructions in the "Installation

Instructions sectzon.

• Is there adequate clearance for maintenance around the water

heater?

• Do you need to call your electric company to check your

wiring?

HOT

CONDUIT_

COLD

TEMPERATURE-

JPRESSURE

RELIEF VALVE

_DISCHARGE PIPE

(Do not capor plug)

I6 AIR GAP

FLOOR DRAIN

MODEL RATING PLATE