Technical data

MultiSensor-LAN
In contrast to the MultiSensor-RF with radio interface the MultiSensor-LAN can also be used stand-alone
without an AlarmManager. For configuration in stand-alone operation a web server is integrated, which
allows you to configure the device via LAN and a web browser. With the SNMP interface, an integration in
network management systems is possible.
Connection via PC:! Connect the LAN jack of the MultiSensor-LAN with your network and your PC
! ! ! using a LAN cable. Please note that you have to use a Cross-Over network cable for
! ! ! a direct connection. Set the IP address of your PC to e.g. „192.168.100.123“.
Default settings / Factory defaults
Voltage supply:!! PoE (Power over Ethernet). Change to external power supply possible.
Default IP-address: ! 192.168.100.223
Subnet mask:! ! 255.255.255.0
User:! ! ! admin
Password:! ! password
Change power supply from PoE to external
By default, the MultiSensor-LAN is set to the power supply over PoE (power over ethernet).
So, you can operate the device without another power supply direct by a PoE capable switch. The market
standard PoE injectors can also be used for power supply.
To operate MultiSensor-LAN over an external power supply, you have to change a jumper (Jumper JP1) on
the platine. Pay attention to the picture below, for switching the jumper.
Changing power supply:
PoE: Jumper to 1 + 2 (POE)
External: Jumper to 2 + 3 (EXT)
IMPORTANT!
Do not change the jumper while
the device is under tension.
Disconnect the device always
from network and power supply.
Important! Reset to factory defaults
If you forgot IP-address or the login information of the MultiSensor-LAN, press the RESET button at the
back of the sensor. The device will reset to factory defaults and reboot. After 30 seconds the MultiSensor
can be accessed with the default IP-address and default user data.
Page 25 ! ! ! ! (08-2014, subject to change) kentix.de