Technical data

MultiSensor-Rack
The MultiSensor-RACK can be operated as stand alone device, but also in combination with an
AlarmManager-PRO. The AlarmManager then controls the environmental sensors.
For configuration in stand alone operation a web server is integrated, which allows you to control and setup
the device via LAN and a web browser.
Over the SNMP interface, an integration in network management systems is possible.
Safety note and installation
In case of a power failure, the settings are not lost. Energized relays drop out and go back when the power
returns to the unswitched, closed output state.
To bridge longer downtimes, use a suitable UPS system.
In case of an equipment failure an uninterruptible power supply to the connected devices is ensured by the
closed state of the relays.
To ensure the security and integrity of the operator and the correct operation of the KENTIX MultiSensor-
RACK, the execution of the installation only has to be done by an expert. Also ensure that the relevant
requirements are met.
Connection via PC:! Connect the LAN jack from the MultiSensor-RACK over a LAN cable with your
! ! ! network and your PC. Pay attention that you have to use a Cross-Over network
! ! ! cable, by a direct connection.
! ! ! Set the IP address of your PC to e.g. „192.168.100.123“.
Default settings
Voltage supply:!! Basic voltage supply realized with PDU-1 power input
Default IP-address: ! 192.168.100.223
Subnet mask:! ! 255.255.255.0
Gateway:! ! 192.168.100.1
User:! ! ! admin
Password:! ! password
Important! Resetting the IP address
If you have forgotten the login information of the MultiSensor-RACK, connect the sensor with a crossover-
cable/adapter to the Ethernet port of your PC. Start the Kentix ControlCenter and enter the network settings.
Eventually deactivate Firewalls and additional network cards. After a short time the sensor will appear in the
lower section of the network dialogue.
Page 36 ! ! ! ! (08-2014, subject to change) kentix.de