Technical data

Active power
The active power (P) shows the actual power of the PDU. Its calculated by multiplying voltage, current and
the power factor.
Apparent power
Total power of the PDU in volt ampere (VA). It results from the idle power and the active power.
Power factor
The power factor is the ratio between active power and apparent power. It indicates which part of the
apparent power is converted to the desired active power.
Energy consumption
Total energy consumption in kilowatt hours (kWh) since the start of the measurement. The consumption
values are stored in the MultiSensor-RACK and preserved even after a restart.
It can be reset in the configurations menu in the EnergySensor section.
Energy costs
Shows the actual costs for the energy consumption since the start of the measurement. The costs result
from the consumption and the configured price.
IMPORTANT!
To display the costs a price has to be entered in the configuration (section EnergySensor).
Output 1/2
Shows the actual state of the outputs (1 output per PDU on MultiSensor-RACK Revision 1, 2 outputs
Revision 2) for the PDUs power supplement of the end devices.
Reset alarms
Resets the display of Flicker-, Swell- and Peak-Alarms.
NOTE!
For actualization of the alarms Flicker, Swell and Peak a Retrigger time is configured which also avoids that
alarms are reported multiple times.
For the actualization / signalization of new alarms resetting the last alarms is not necessary.
Page 40 ! ! ! ! (08-2014, subject to change) kentix.de