Technical data

SMS commands for remote control of AlarmManager
The AlarmManager reports not only all the alarms via SMS, it can be also remotely controlled via simple
SMS commands from a mobile phone. This brings the big advantage of having the central alarm system in
your pocket and remotely setting the system to the desired states.
The AlarmManager can be armed or disarmed and alarms can be acknowledged remotely. So you can
decide if it is necessary to intervene on the ground at any time by using the SMS information and status
inquiry.
Important notes for remote control of the AlarmManagers via SMS
Upper- and lower-case can be used.
Between „Operator-PIN“ and „COMMAND“ is always a space.
The „Operator-PIN“ can have 4-8 alphanumerical characters. Setup the PIN with the ControlCenter.
The AlarmManager is confirming each command SMS with an SMS back to the sender.
Command SMS with the wrong phone number or password will not be confirmed for security reasons.
SMS control commands
SMS command
Description
Example
Confirmation
{PIN} ON
Arming of the AlarmManagers. All zones will be
armed..
1234 on
OK! ARM All Zones
{PIN} ON{ZONE}
Arming of the selected zone.
1234 on1
OK! ARM ZONE 1
{PIN} OFF
Disarming of all zones.
1234 off
OK! DISARM All Zones
{PIN} QUIT
Acknowledge of all pending alarms. The alarm
repetition is terminated.
The AlarmManager can be set to arm state again.
1234 quit
OK! ALARM QUIT
{PIN} STATE
The AlarmManager sends the actual system
state.
1234 state
OK! ARMED/DISARMED/
ALARM
{PIN} MSTATE1-n
The AlarmManager sends the actual system state
and values of a MultiSensor.
Enter the number of the MultiSensor (1-100)
directly after the command „MSTATE“.
The response contains the name of the
MultiSensor.
1234 mstate1
OK! SENSORNAME:
TEMP=20C
REL-HUM=25%
DEW-POINT=3C
MOTION=15%
EXT-IN=0
SABOTAGE=0
POWER=OK
! ! Example: Arm-disarming of the AlarmManager via SMS command
NOTE!
When a sensor sends an alarm, the SMS contains the number of the sensor to send a mstate request.
OK! ARM ZONE 123
1234 on
SMS command
SMS answer
Page 14 ! ! ! ! (08-2014, subject to change) kentix.de