Technical data

1. If possible, install the MultiSensor-RACK at the top position in the
rack and leave 1 height unit free below the device.
This ensures that the environment sensors can detect the actual
state in the rack.
2. For the installation of the mounting brackets only use the included
screws. The mounting brackets can be attached to two different
positions for installation either to the front or to the back support
rail.
3. Connect the power cable of the power consumers to
PDU 1 or 2 and secure them with the provided strain relief.
ConfigurationConfiguration
In the following the stand alone functionality of the integrated web servers is described. For these functions
no AlarmManager is required. If you use the MultiSensor-RACK in combination with an AlarmManager-PRO,
configuration and monitoring of the environment sensors is done via the AlarmManager. The energy
measurement and its alarming states are exclusively found in the web interface.
Navigation
Dashboard! ! - Start page with environment sensors, Energy measurement,
! ! ! Control of the digital Output 2 and PDU 1+2, Logbook
Login! ! ! - User login
Configuration! ! - Basic configuration, MultiSensor- / EnergySensor- and User-configuration
System!! ! - System information (software version), test features, logbook and device-restart
Help ! ! ! - Manual download and support information
Logout! ! ! - User logout
Important!
The MultiSensor-RACK extends the MultiSensor-LAN by the energy measurement functions. The
MultiSensor functionality corresponds the functionality of the MultiSensor-LAN except for the motion sensor.
To configure MultiSensor settings, read the according section in the MultiSensor-LAN configuration.
Page 38 ! ! ! ! (08-2014, subject to change) kentix.de