User Manual

11
EMERGENCY OPERATION
There are two Emergency Operation modes: Emergency Operation 1 and
Emergency Operation 2.
Press and hold the key programmed as Emergency to enter Emergency
Operation 1.
• The transceiver will beep unless your dealer has activated “Secret” Emergency
Operation 1.
• The channel will switch to the pre-programmed emergency channel.
While in “Secret” Emergency Operation 1, the Busy indicator lights every
10 seconds, indicating that you are in Emergency Operation 1. When your signal
has been acknowledged, the Busy indicator will light 2 times every 10 seconds.
Press and hold the Emergency key again to enter Emergency Operation 2.
• The transceiver will beep unless your dealer has activated “Secret” Emergency
Operation 2.
While in “Secret” Emergency Operation 2, the transceiver will wait for 1 minute,
then activate the function attached to its control function port. This could be your
car horn or headlights. When the transceiver receives an Emergency Reset
code, it will return to normal operation. Or, if you press and hold the Emergency
key for more than 10 seconds, you can return the transceiver to normal
operation.
If enabled by your dealer, the transceiver can continue Emergency Operation
even while the transceiver power is OFF.
KEY LOCK
Press the key programmed as Key Lock to lock the keys of the transceiver.
Locking the transceiver keys prevents you from accidentally changing the
channel and channel settings. While key lock is active, you can still use the
microphone PTT switch, the (power) switch, and the Emergency, Monitor, ▲,
and ▼ keys.
Press the Key Lock key again to turn this function OFF.
BEGINNING/ END OF TRANSMISSION ID SIGNAL
Your dealer can enable or disable the Beginning/ End of Transmission
identification signals. These signals are used to access and release some
repeaters and telephone systems.
A Beginning of Transmission ID Signal is sent when you press the PTT switch.
An End of Transmission ID Signal is sent when you release the PTT switch.