KSC-SW11 POWERED ENCLOSED SUBWOOFER INSTRUCTION MANUAL CAISSON D’EXTRÊME GRAVE AMPLIFIÉ MODE D'EMPLOI GEKAPSELTER SUBWOOFER MIT VERSTÄRKER BEDIENUNGSANLEITUNG SUBWOOFER MET SPANNINGSCIRCUIT GEBRUIKSAANWIJZING ENGLISH FRANÇAIS DEUTSCH B61-1376_1_EN_00_KSC-SW11.indd 1 NEDERLANDS © B61-1376-00/00 (W) KW 12.11.
IMPORTANT SAFETY INSTRUCTIONS Caution: Read this page carefully to ensure safe operation. WARNING • Before mounting or wiring etc., be sure to remove the wire from the battery minus terminal. (Not doing so can cause shorts or fires.) • When extending the ignition, battery, or ground wires, make sure to use automotive-grade wires or other wires with a 0.75mm2 (AWG18) or more to prevent wire deterioration and damage to the wore coating.
Parts included No. Part Name Outside Shape Quantity No. Part Name Outside Shape Quantity Remote control 1 (5 m / 16 ft) 1 Tapping screw 6 (ø 5 × 16 mm) 4 10-pin connector cord 2 (5 m / 16 ft) 1 Machine screw 7 (M4 × 5 mm) 4 Speaker cord 3 (4.
Connection Speaker p input p connection Connect the subwoofer to the front speaker or rear speaker output cords of the center unit. Notes: • Read the instruction manuals for the connected components such as the center unit as well as this instruction manual. • When the center unit incorporates a DSP, do not connect to the rear output, as the low-frequency reproduction effect may be attenuated due to the DSP effect. ■ Examples The following shows a typical connection for effective car stereo enjoyment.
RCA input p connection Connect the subwoofer to the subwoofer output (non-fader output) or the RCA jacks for the front output of the center unit. Notes: • Read the instruction manuals for the connected components such as the center unit as well as this instruction manual. • Please purchase an RCA cord that is commercially available separately. • When the center unit incorporates a DSP, connect the subwoofer to the subwoofer output (non-fader output) or to the RCA jacks for the front output.
Installation Before fixing the speaker in its position, be sure to check the sound while it is connected preliminary. Caution: • When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing hazardous on the opposite side such as a gasoline tank, brake pipe; or wiring harness, and be careful not to cause scratches or other damage.
■ Installing the remote control unit Install the remote control unit on the vehicle by the provided hook-and-loop fastener. 1 Remote control (Rear panel) Vehicle 9 Hook-and-loop fastener (Harder surface) Caution: Install the remote control unit in a position that does not come in the way of driving operations. Avoid installing it in a place subject to direct sunlight or direct hot wind from the heater. Otherwise, the product may be degraded and a fire hazard may result.
Troubleshooting g guide g Often, what appears to be a malfunction is due to user error. Before calling for service, please consult the following table. Problem Power cannot be turned on (illumination does not light). Cause Remedy • The fuse is blown. • Check the (+)/(-) polarity of the power cord and that the cords are not shorted, then replace with a fuse with the rated capacity. • Re-connect the cords correctly by referring to the connection example (on page 4, 5).
ENGLISH English B61-1376_1_EN_00_KSC-SW11.indd 9 9 12.11.
