Dear audio fan The purpose of this manual is 10 acquaint you with the operating features of your new amplifier. You will notice that in every detail of planning, engineering, styling, operating convenience, and adaptability, we have sought to anticipate your needs and desires. We suggest that you read this manual carefully. Knowing how to set up your amplifier to the best advantage will enhance your listening pleasure right from the start.
Before operation Notes on installation Do not place the unit in a place which is exposed 1o direct sunlight, near a heating appliance, etc Do not place & vase containing water, makeup, etc. on the unit. Do not use N a hurried place O = To maintain good ventilation, do not put records or a while-cloth on the unit. Place the unit at least 10 om away forestalls Choose a location that is relatively free from vibration or excessive dust Safety precautions Never remove the case.
Speakers This amplifier has two pairs of speaker terminals, SPEAKERS A and SPEAKERS B Connecting one speaker system Connect speakers rated at 4 ohms or more o the SPEAKERS A terminals Although ordinary speaker cords can be connected o the SPEAKERS A terminals, the ¥ drive system will reproduce better sound with the I cables connected to the SPEAKERS A terminals. Speaker cords Fig. 1 shows ordinary speaker cords available on the market, which can be used as a £ cord.
Controls, indicators and connectors GREENWOOD 1o oo s heaviness, s Bess © POWER switch/indicator Crass the popover switch 1w tare o the power . To s the power off, press the switch again to set it 10 the out position. © PHONES jack This jack accepts the standard stereo headphone plug when vou wish to listen through headphones alone, set the SPEAKERS pushchairs (A and B} both at the OFF {Out} position In case of difficulty i .
Block diagram BO Hz m ok INPUT HIGH { Oy POWER 7 owes SPEAKER { A HLO CURRENT N SWITCH LIMITER 5 HEn . Low i POWER ' 8 DELAY DRIVER HEADPHONE i Ot % LAMP T 120V AC Specifications Power output 1085 watts per channel minimum RMS, both channels driven, at 8 ohms from 20 Hz to 20,000 Hz with no more than 0.005% total harmonic distortion, Clipping Power a1 8 ohms at4 ohms Clipping Headroom at8 ohms at 4 ohms Dynamic Power at 8 shins at4 ohms Dynamic Headroom ratbag ohms at4 ohms .