OPENWORK C907 COMPACT DISC AUTO CHANGER INSTRUCTION MANUAL CHANGER AUTOMATIZE DE DIS QUES COMPACTS MODE EMPLOY'S CAMBIAL AUTOMATIC DE DISCOS COMPACTS MANUAL DE INSTRUCTIONS KEN WOOD CORPORATION COMPACT . DIGITAL AUDIT Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new compact disc auto changer.
varying The marking of products using lasers {Except for some areas) CLASS 1 LASER PRODUCT The label is attached 1o the chassis/case and says that the component uses laser beams that have bean classified as Class 1. It means that the unit is using laser beams that are of & rakes sass, There is ne gender of hazardous attraction outside the unit. .
1GL Felicitation Take the following precautions to prevent fire and avoid personal injury : « Check that no metal objects icons, tools, st) are left inside the unit to avoid short Circuits. ¢ If you smell or see smoke, turn the power off immediately and consult your Ken wooed ale. CAUTION Take the following precautions to keep the unit in proper working order. * Do not open the tap or bottom cover.
Précautions de sécurité Pour éviter tout risque de feu et de blessures physiques, observer les précautions suivantes: »Vérifier que I'on n'a pas laissé déchets métalliques {piges de monnaie, outils, etc.) a i'intérieur de I'appareil, afin d'éviter les courts-circuits ¢l ors dégagement d'odeur ou de fumée, éteindre Immédiatement apparie! et consulta son agent Kendo. ATTENTION Pour maintenir I'appareil en parfait état de marche, observer les précautions suivantes.
Introducción de discos compactos 1. Reservase de que el cartucho de discos esté debidamente orientado hacia arriba, con el logotipo "sise’ hacia arriba. extraiga la bandeja por medica del saliente 2. Coligue ¢! dice en la bandee con la etiqueta dirigida hacia arriba. Inserte la bandeja en el cartucho de discos hasta que encaje.
connections / accouterments / Condones Changer contra terminal / Borne de command du changer / Terminal de control de cambial > de [en option} Uni dad de control (corporal} ® Changer control cable (5m) / Cable de command du changer (5 mi/ Cable de control de cambial (5 m) Changer No. switch / Commutator de No. de changer / Interrupter de selection del N2 de cambial B Connections CAUTION * Do not connect the changer control cable while the control unit is turned ON.
Troubleshooting Guide PROBLEM POSSIBLE CAUSE SOLUTION The disc changer mode cannot No cable has been connected tc the Connect the cable to the disc changer be selected. disc changer input terminal on the input terminal on the unit. unit, The specified disc does not * The specified CD is very dirty. » Clean the CD. play, but anther one plays * The CD is upside-down # Load the CD with the {belled side instead. up = The disc is laded in a different slot » Eject the ¢ magazine ant check trim that specified.