Operation Manual

22
• Inside of oven: The oven should
always be cleaned after use when it
has cooled down. The cavity should be
cleaned using a mild detergent solution
and warm water. Suitable proprietary
chemical cleaners may be used only
on enamel after rst consulting the
instructions supplied with the oven
cleaner and testing a small sample
on the oven cavity. Abrasive cleaning
agents or scouring pads/cloths should
not be used on the cavity surface.
 NOTE: The manufacturers of this
appliance will accept no responsibility
for damage caused by chemical or
abrasive cleaning.
 Let the oven cool down and pay
special attention not to touch the
hot heating elements inside the
oven cavity.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains.
When the cooker is cool unscrew and
replace the bulb with another one resistant
to high temperatures (300°C), voltage
230V or 220-240V, type E14 and same
power (check watt power as stamped in the
bulb itself) of the replaced bulb.
Note: Oven bulb replacement is not
covered by your guarantee.
BURNERS
They can be removed and washed with
soapy water only.
They will remain always perfect if cleaned
with products used for silverware.
After cleaning or wash, check that burner-
caps and burner-heads are dry before
placing them in the respective housings.
Check that the electrode “S” (gs. 8.1,
8.3)
next to each burner is always clean to
ensure trouble-free sparking.
Check that the probe “T”(gs.8.1,8.3)next
to each burner is always clean to ensure
correct operation of the safety valves.
Both the probe and ignition plug must
be very carefully cleaned.
To avoid damage to the electric ignition
do not use it when the burners are not
in place.
CORRECT REPLACEMENT OF
THE AUXILIARY AND SEMI-RAPID
BURNERS
It is very important to check that the burner
ame distributor “F” and the cap “C” has
been correctly positioned (see gs. 8.1 -
8.2) - failure to do so can cause serious
problems.
CORRECT REPLACEMENT OF THE
TRIPLE RING BURNER
The triple ring burner must be correctly
positioned (see g. 8.5); the burner rib
must be enter in their logement as shown
bythearrow(seeg.8.3).
The burner correctly positioned must not
rotate(g.8.4).
Then position the cap “A” and the ring “B”
(gs.8.4-8.5).