Operation Manual

28
Fig. 9.1
9 - INSTALLATION
LEVELLING
The cooker is equipped with 4 levelling
feetwhichmustbettedtothebaseofthe
cooker in the following manner:
• Place the cooker on its back as shown
inthegure9.2.
• Screw the 4 leveling feet to the cooker.
• Stand the cooker and levelling it by
screwing or unscrewing the feet with
a spanner.
Fig. 9.2
This cooker has class “2/1” overheating protection so that it can be installed next
to a cabinet.
If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a
gap of at least 50 mm must be left between the side of the cooker and the furniture.
Thewallsandkitchenfurnituresurroundingtheappliancemustbemadeofnon-ammable
material. The veneered synthetical material and the glue used must be resistant to a
temperature of 90°C in order to avoid ungluing or deformations. It is recommended that
a 10 mm gap to each side is made if the adjacent kitchen furniture is made of a plastic
laminate wrap.
Curtainsmustnotbettedimmediatelybehindapplianceorwithin500mmofthesides.
It is essential that the cooker is positioned as stated below.
We do not recommend the
cooker is located on a plinth.
If this is unavoidable, it will
be necessary to provide
safety measures to prevent
the appliance falling off.
The cooker must be
installed by a suitably
qualied technician and
in compliance with local
safety standards.
450 mm
50 mm
500 mm
650 mm