Operation Manual

37
ANTI-TILT BRACKET
Warning:Thisappliancemustberestrainedtopreventaccidentaltippingbyttinga
brackettotherearoftheapplianceandsecurelyxingittothewall.
Tottheanti-tiltbracket:
1. After you have located where the cooker is to be positioned, mark on the wall the
placewherethe2screwsoftheanti-tiltbrackethavetobetted.Pleasefollowthe
indicationsgivening.8.8.
2. Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied.
 Important! Before drilling the holes, check that you will not damage any pipes
or electrical wires.
3. Loosely attach the anti-tilt bracket with the 2 screws supplied.
4. Move the cooker to the wall and adjust the height of the anti-tilt bracket so that it can
engageintheslotonthecooker’sback,asshowning.8.8.
5. Tighten the screws attaching the anti-tilt bracket.
6. Push the cooker against the wall so that the anti-tilt bracket is fully inserted in the slot
on the cooker’s back.
 Attention!
 When sliding the cooker into place pay special attention not to trap the power
supply cable in the stability bracket.
 Pay special attention to the gas connection hose.
Fig. 8.8