Operation Manual

20
CORRECT REPLACEMENT OF THE
AUXILIARY, SEMI-RAPID AND RAPID
BURNERS
It is very important to check that the burner
ame distributor “F” and the cap “C” have
been correctly positioned (see gs. 8.1,
8.2) - failure to do so can cause serious
problems.
CORRECT REPLACEMENT OF THE
TRIPLE RING BURNER
The triple ring burner must be correctly
positioned (see g. 8.5); the burner rib
must be enter in their logement as shown
by the arrow (see g. 8.3).
Then position the cap “A” and the ring “B”
(gs. 8.4, 8.5).
The burner correctly positioned must not
rotate (g. 8.4).
CLEANING THE HOB
Spillage on the hob can usually be removed
by a damp soapy cloth. More obstinate
stains can be removed by rubbing gently
with a soapy nylon (non metal) scouring
pad or mild household cleaner.
FLEXIBLE TUBE
From time to time, check the exible tube
connecting the gas supply to the cooker.
It must be always in perfect condition;
in case of damage arrange for it to be
replaced by a suitably qualied and
registered installer.
GAS TAPS
If a tap becomes stiff, do not force; contact
your Local Service Centre.
BURNERS AND PAN SUPPORTS
These parts can be removed and cleaned
with appropriate products.
After cleaning, the burners and their ame
spreaders must be well dried and correctly
replaced.
It is very important to check that the burner
ame spreader and the cap have been
correctly positioned. Failure to do so can
cause serious problems.
Check that the electrode “S” (gs. 8.1,
8.3) next to each burner is always clean to
ensure trouble-free sparking.
Check that the probe “T” (gs. 8.1, 8.3) next
to each burner is always clean to ensure
correct operation of the safety valves.
Both the probe and ignition plug must
be very carefully cleaned.
Note: To avoid damage to the electric
ignition do not use it when the burners
are not in place.