Installation Guide

4
|
DNX SERIES/ DDX SERIES
PRK SW
ILLUMI
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Connection
Connector Function Guide
Pin Numbers for
ISO Connectors
Cable Colour Functions
External Power
Connector
A-4 Yellow Battery
A-5 Blue/White Power Control
A-6 Orange/White Dimmer
A-7 Red Ignition (ACC)
A-8 Black Earth (Ground) Connection
Speaker
Connector
B-1 Purple Rear Right (+)
B-2 Purple/Black Rear Right (–)
B-3 Gray Front Right (+)
B-4 Gray/Black Front Right (–)
B-5 White Front Left (+)
B-6 White/Black Front Left (–)
B-7 Green Rear Left (+)
B-8 Green/Black Rear Left (–)
Battery wire (Yellow)
Ignition wire (Red)
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
Power control/ Motor antenna control wire
(Blue/White)
Dimmer control wire (Orange/White)(Orange/White)
Antenna Cord
FM/AM antenna
input (JASO)
If no connections are made, do not let the cable come out from the tab.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
Mute control wire (Brown)
To connect the Kenwood navigation system,
consult your navigation manual.
Parking sensor wire (Light Green)
Connect to the vehicle's parking brake
detection switch harness.
For the sake of safety, be sure to connect the parking sensor.
Steering remote control wire
(Light Blue/Yellow)
To steering remote
Reverse sensor wire (Purple/White)
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
Connector A
Connector B
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
⁄
⁄
⁄
⁄
B54-4763-00_00_DNX5_E_En_r1.indd 4B54-4763-00_00_DNX5_E_En_r1.indd 4 09.11.11 5:36:32 PM09.11.11 5:36:32 PM