Owner's Manual

Settings
Settings
4
Select the crossover network mode.
[2way] Select this when connecting speakers
in a 2-way system (front/rear).
[3way] Select this when connecting speakers
in a 3-way system (tweeter/mid
range/woofer).
A confirmation message appears. Touch [Yes] to
confirm.
Setting the speakers and crossover
frequency
1 Select a car type (1), select the location
of the speakers (
2), then display the
<Speaker Select> screen (
3).
• Only for DDX396/DDX419BT: Speaker location
selection is available only when <X’over
Network> is set to [2way].
<Speaker/X’over>
Crossover network mode settings
(Only for DDX396/DDX419BT)
Before making any settings for the speakers and
crossover frequency, select the appropriate crossover
network mode according to the speaker system (2-way
speaker system or 3-way speaker system).
• Connecting 3-way speakers with 2-way crossover
network mode selected may damage the speakers.
1 Display the source/option selection screen.
On the Home screen, touch as follows:
2 Put the unit in standby.
On the source/option selection screen, touch as
follows:
3 Press the following buttons/knob on the
monitor panel at the same time to display
the <X’over Network> screen.
• DDX396: MENU button and ATT knob
• DDX419BT: MENU button and CAM button
2 Select the speaker type (1), select the size
of the selected speaker (
2), then display
the <X’over> screen (
3).
• If a speaker is not connected, select <None>.
• When setting the front speakers, also select the
speaker size for <Tweeter>.
41
ENGLISH
00_DDX_2019ST_KN_RN.indb 41 31/5/2018 2:44:28 PM