Owner's Manual

64 ENGLISH
REVERSE
PRK SW
P.CONT
[
MUTE
ANT CONT
¥
D23
D22
D21
C5
A
Å
*
«
STEERING
REMOTE
Installation and Connection
Installation and Connection
USB input terminal (1 m)
Connect the antenna cord from the power cord (
A ) to the antenna
terminal.
Antenna cord: Connect to the antenna terminal.
For DDX718WBTL
Connector D: To the car’s steering remote harness
• Depending on the type of vehicle, it cannot be
connected.
Connector B: To the car’s harness
Connector A: To the car’s harness
Connector C: To the car’s harness
10 A fuse
Light green
Extension wire (
ø )
To the car’s parking brake detection switch harness
(For best safety, be sure to connect the parking sensor.)
Purple with white stripe
To the car’s reverse lamp harness when using the optional rear view camera
Blue with white stripe
(12 V
350 mA)
Brown
To the control terminal of the motor antenna or to the power terminal for
the booster amplifier of film-type antenna
Pin Color and Function
A
A1 Orange/White: Dimmer
A2 Yellow: Battery
A3 Blue: Antenna control
A4 Red: Ignition (ACC)
A5 Blue: Antenna control
A6 Black: Ground connection
A7/A8
White with black stripe
[ / White ] : Left speaker (front)
A9/A10
Gray with black stripe
[ / Gray ] : Right speaker (front)
B
B1/B2
Green with black stripe
[ / Green ] : Left speaker (rear)
B5/B6
Purple with black stripe
[ / Purple ] : Right speaker (rear)
C C5 Blue: Antenna control
D
D21 White: Input 1
D22 Red: Input 2
D23 Black: Ground
* When using Antenna Control, connect the ANT CONT lead (blue)
to A5 (blue) on the wiring harness.
Not used.
ENDDX2018TCKR.indb64 2017/11/3015:35