Owner's Manual

Table Of Contents
DNX6960/DNX6160/DNX6020EX/DNXS160/DDX616/DDXS16:
I ACAUTION I
Use
of controls or adjustments or performance of procedures other than those specified herein
may
result
in
hazardous
radiation
exposure.
In
compliance with
Federal
Regulations,
following
are
reproductions
of
labels
on,
or
inside the product relating to
laser
product
safety.
Kenwood
Corporation
2967-3,
ISHIKAWA-MACH
I,
HACHIOJI-SHI
TOKYO,
JAPAN
KENWOOD
CORP
CERTIFIES
THIS
EQUIPMENT
CONFORMS
TO
DHHS
REGULATIONS
NO.21
CFR
1040.
10,
CHAPTER
1,
SUBCHAPTER
J.
Location: Bottom
Panel
FCC
WARNING
This
equipment
may
generate
or
use
radio frequency
energy.
Changes
or
modifications to this equipment
may
cause
harmful
interference
unless
the modifications
are
expressly
approved
in
the instruction
manual.
The
user
could
lose
the authority to
operate this equipment if
an
unauthorized change
or
modification
is
made.
NOTE
This
equipment
has
been
tested
and
found to comply with the limits for a
Class
Bdigital
device,
pursuant to
Part
15
ofthe
FCC
Rules.
These
limits
are
designed to provide
reasonable
protection
against
harmful interference
in
a residential installation.
This
equipment
may
cause
harmful interference to
radio
communications, if it
is
not installed
and
used
in
accordance
with the
instructions.
However,
there
is
no
guarantee that interference will not occur
in
a particular installation.
If
this equipment
does
cause
harmful interference to
radio
or
television reception, which
can
be
determined
by
turning the equipment off
and
on,
the
user
is
encouraged
to
try
to
correct the interference
by
one
or
more
ofthe following
measures:
Reorient
or relocate the receiving antenna.
Increase
the separation between the equipment
and
receiver.
Connect the equipment into
an
outlet
on
a circuit different from that to which the
receiver
is
connected.
Consult the dealer or
an
experienced radiofTV technician for help.
Contains
Transmitter Module
FCC
ID
:
RKXCK5000NVIA
Contains
Transmitter Module
IC
ID
:
5119A-CKSOOONVIA
IC
(Industry Canada) Notice
Operation
is
subject
to
the following
two
conditions:
(1)
This
device may not
cause
interference, and
(2)
this device must accept any interference, including interference that may cause undesired operation
of
the
device.
The
term
"IC:
" before
the
certification/registration number only signifies that the Industry
Canada
technical
specification were met.
KENWOOD