Owner's Manual

To prevent injury or fire, take the following
precautions:
o To prevent a short circuit, never put or leave any
metallic objects (such
as coins or metal tools) inside
the unit.
o Do not watch or fix your eyes on the unit's display
when you
are driving for any extended period.
How to reset your unit
• If the unit or the connected unit fails to operate
properly,
press the Reset button. The unit returns to
factory settings when the Reset button is pressed.
o Remove the USB device before pressing the Reset
button. Pressing the Reset button with the USB
device installed can damage the data contained in
the
USB device. For how to remove the USB device,
see <How to Set a Medium / a Device> (page 13).
o When the unit is turned on after pressing the Reset
button, the Initial SETUP screen is displayed. (page
90)
Cleaning the unit
If the faceplate of this unit is stained, wipe it with a
dry soft cloth such
as a silicon cloth.
If the faceplate
is stained badly, wipe the stain off
with a cloth moistened with neutral cleaner, then
wipe
it again with a clean soft dry cloth.
~
o Applying spray cleaner directly to the unit may affect its
mechanical parts. Wiping the faceplate with a hard cloth
or using a volatile liquid such
as thinner or alcohol may
scratch the surface or
erases characters.
Lens fogging
When you turn on the car heater in cold weather,
dew or condensation may form on the lens in the
disc player
of the unit. Called lens fogging, this
condensation on the
lens may not allow discs to play.
In such a situation, remove the disc and wait for the
condensation to evaporate. If the unit still does not
operate normally after a while, consult your Kenwood
dealer.
Handling discs
o Do not touch the recording surface of the disc.
o Do not stick tape etc. on the disc, or use a disc with
tape stuck on it.
o Do not use disc type accessories.
o Clean from the center of the disc and move
outward.
o When removing discs from this unit, pull them out
horizontally.
• If the disc center hole or outside rim
has burrs,
use the disc only after removing the burrs with a
ballpoint pen etc.
Discs that cannot be used
o Discs that are not round cannot be used.
®
• Discs with coloring on the recording surface or
discs
that are dirty cannot be used.
•
This unit can only play the CDs with ffiJ!m ffiJm ffiJm
--ili!IiiIii'ia:=
This unit may not correctly play discs which do not
have the mark.
•
You cannot playa disc that has not been finalized.
(For the finalization process refer to your writing
software, and your recorder instruction manual.)
o If you try to load a 3-inch-disc with its adapter into
the unit, the adapter might separate from the disc
and damage the unit.
Other notes
o If you experience problems during installation,
consult your Kenwood dealer.
o When you purchase optional accessories, check
with your Kenwood dealer to make sure that they
work with your model and in your area.
o Characters that conform to ISO 8859-1 can be
displayed.
• The
RDS or RBDS feature won't work where the
service is not supported by any broadcasting
station.
Protecting the monitor
To protect the monitor from damage, do not operate
the
monitor using a ball point pen or similar tool with
the sharp tip.
4 DNX SERIES DNX6960/DNX6160/DNX6020EX/DNX6460BT/DNXS160