MONITOR WITH DVD RECEIVER DDX8029 INSTALLATION MANUAL © B54-4535-00/00 (EV/E2V) DDX8029_B54-4535-00_eng.indd 1 07.2.
Accessories 1 ..........1 2 ..........1 3 ..........2 4 ..........1 5 ..........1 2 | DDX8029 DDX8029_B54-4535-00_eng.indd 2 07.2.
Installation Procedure 1. To prevent short circuits, remove the key from the ignition and disconnect the - terminal of the battery. 2. Make the proper input and output wire connections for each unit. 3. Connect the wire on the wiring harness. 4. Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle. 5. Take Connector A on the wiring harness and connect it to the external power connector on your vehicle. 6. Connect the wiring harness connector to the unit. 7.
Connection Connecter A Ground wire (Black) 8 7 6 5 4 3 2 1 8 7 6 5 4 3 2 1 FUSE ( 5A ) Battery wire (Yellow) Ignition wire (Red) Connecter B Antenna Cord (ISO) (Orange/White) Connect to the vehicle's parking brake detection switch harness using the supplied relay connector. Accessory 4 (ISO-JASO) Dimmer control wire (Orange/White) ILLUMI Parking sensor wire (Light Green) PRK SW For the sake of safety, be sure to connect the parking sensor.
Rear view Cooling fan FM/AM antenna input FUSE ( 10A ) Accessory 1 REVERSE REMO.CONT MUTE ANT. CONT P CONT EXT.CONT English | DDX8029_B54-4535-00_eng.indd 5 5 07.2.
Connecting Wires to Terminals Connector Function Guide Pin Numbers for ISO Connectors External Power Connector A-4 A-5 A-6 A-7 A-8 Cable Colour Functions Yellow Blue/White Orange/White Red Black Battery Power Control Dimmer Ignition (ACC) Earth (Ground) Connection Speaker Connector B-1 B-2 B-3 B-4 B-5 B-6 B-7 B-8 Purple Purple/Black Gray Gray/Black White White/Black Green Green/Black Rear Right (+) Rear Right (–) Front Right (+) Front Right (–) Front Left (+) Front Left (–) Rear Left (+) Rear Left (–
System Connection USB terminal (iPod) USB terminal USB device (commercially available) USB device (commercially available) iPod RELAY 1 RELAY 2 Do not connect.
Optional Accessory Connection iPod (commercially available) Navigation System (Optional Accessory) KCA-iP300V (Optional Accessory) Audio Input iPod AUDIO IN Audio Output (Black) Connection cable (Included in the Navigation System) Visual Input iPod VIDEO IN Visual Output (Yellow) Rear view USB terminal iPod USB terminal (iPod) USB terminal iPod cannot be connected. Connection cable (Included in the Disc changer) Disc Changer etc.
Installation for Monitor/Player Unit Firewall or metal support Screw (M4X8) (commercially available) Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Self-tapping screw (commercially available) Metal mounting strap (commercially available) Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). Installing the Escutcheon Accessory 5 English | DDX8029_B54-4535-00_eng.indd 9 9 07.
Removing Monitor/Player Unit Removing the Hard Rubber Frame (escutcheon) 1. Engage the catch pins on the removal tool 3 and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. Accessory 3 Removing the Unit 1. Remove the hard rubber frame by referring to the removal procedure in the section . 2. Remove the Hex-head screw with integral washer (M4 × 8) on the back panel. 3.
DDX8029_B54-4535-00_eng.indd 11 07.2.
DDX8029_B54-4535-00_eng.indd 12 07.2.