Owner's Manual

26
Connection/Installation
'
Installing the unit
I
[i Non-Japanese cars
(Except DDX819WBTL)
[i Japanese cars
NOTE
Bend the tabs of the
mounting sleeve
with a screwdriver
or similar utensil and
attach it in place.
~
®or(J)
• Make sure that the unit is installed securely in
place. If the unit is unstable, it may malfunction
(eg, the sound may skip).
[i Trim plate
(Except DDX819WBTL)
1) Attach accessor y® to the un it.
®
[i GPS antenna
(Except DDX819WBTL)
GPS antenna is installed inside of the car. It
should be installed as horizontally as possible
to allow easy recept i on of the GPS satellite
signals.
To mount the GPS antenna inside your vehicle:
1) Clean your dashboard or other surface.
2) Remove the separator of the metal plate
(accessory@)).
3) Press the metal plate (accessory@)) down
firmly on your dashboard or other mounting
surface. You can bend the metal plate
(accessory@)) to conform to a curved surface,
if necessary.
4) Remove the separator of the GPS antenna
(accessory®), and stick the antenna to the
metal plate (accessory@)).
NOTE
• Use the supplied GPS antenna. Using the GPS
antenna other than the supplied one may cause a
drop in positioning accuracy.
• Depending on the type of car, reception of the
GPS satellite signals might not be possible with
an inside installation.
• Please install this GPS antenna in an area away
from any antennas that are used with CB radios or
satellite televisions.
• The GPS antenna should be installed at a position
that is spaced at least 12 inch (30 cm) from
cellular phone or other transmitting antennas.
Signals from the GPS satellite may be interfered
with by these types of communication.
• Painting the GPS antenna with (metallic) paint
may cause a drop in performance.