Owner's Manual
Table Of Contents
- Instruction Manual
- Quick Start Guide
- Contents
- Before Use
- Basic Operations
- Disc
- USB/iPod
- HD Radio™ Tuner/Radio
- Bluetooth Control
- Controlling Audio
- Connection/Installation
- Before Installation
- Installing the unit
- Non-Japanese cars (Except DDX819WBTL)
- Japanese cars
- Trim plate (Except DDX819WBTL)
- GPS antenna (Except DDX819WBTL)
- Microphone unit
- Removing the trim plate (Except DDX819WBTL)
- Removing the unit (Except DDX819WBTL)
- Connecting wires to terminals
- 3-way speaker system setup
- Connecting the system and external components
- Securing the USB extension cable
- Connecting a USB device
- Connecting an iPod/iPhone
- Connecting an Android smartphone
- Connecting the camera
- To set up the cameraassignment settings
- Appendix
- Warranty
Setup
85English
6
Adjust the date, then adjust the time.
7
Touch [Set].
Ñ Touch panel adjustment
1
Touch [Touch Panel Adjust] on the User
Interface screen.
Touch Panel Adjust screen appears.
2
Follow the instruction on the screen and
long touch the center of each [ ].
1
2
NOTE
• To cancel the touch panel adjustment, touch
[Cancel].
• To reset it to the default, touch [Reset].
Ñ Learning function of steering
remote (DDX819WBTL)
This function is available only when your
vehicle is equipped with the electrical steering
remote controller.
If your steering remote controller is not
compliant, learning may not be completed
and error message may appear.
1
Touch [Steering Remote Controller] in
the User Interface screen.
Steering Remote Controller Setting
screen appears.
2
Press and hold the steering remote
controller button.
NOTE
• You can have the unit learned all buttons
at a time. In that case, press the all buttons
one at a time and after pressing all of them,
touch [Learning completed] in Steering
Remote Controller Setting screen. However,
new functions cannot be learned after this
operation.
3
Touch the function you want to set.
4
Repeat steps 2 and 3 as necessary.
5
Touch [Learning completed].
NOTE
• When changing the function already learned,
press and hold the button you want to change
in step 2 and then touch to select the changed
function from the function list.
• Confirm the contents of the settable function on
the function list. You cannot edit the function list.
• To initialize the contents, touch [Learning
initialisation] of [Steering Remote
Controller] in User Interface screen. After you
touch [Initialise], a confirmation message
appears. Follow the message and complete the
operation.