- Xitel MD-Port users manual DG1

Windows 2000

Once Windows 2000 starts and the appropriate drivers have been loaded, the DG1 will automatically be

set as your system's preferred audio device. To verify this, open the Sounds and Multimedia panel and

make sure that USB Audio Device appears in the Playback section under the Audio tab. To get to the

multimedia control panel hit Start, then go to Settings, then Control Panel. The Sounds and Multimedia

icon will be in the Control Panel window. Double click on the icon. In the Audio tab, make sure that USB

Audio Device appears in the Sound Playback section. If it doesn't, use the scroll arrow to the right and

choose USB Audio Device. You're now fully loaded.

Controlling the output and volume levels

The DG1's volume and output controls can be accessed by double clicking the

standard volume control icon. The volume for the DG1 is set by the Wave

Balance slider, which is the only slider that the DG1 uses. If there are other

sliders visible, go to Options and then Properties. In the bottom section of the

Properties window, make sure a check appears only next to Wave Balance.

Click on OK once you're done.

computer will automatically configure for whatever soundcard is

installed. In both cases, it doesn't matter if the system is on or off.

For smooth automatic loading, please ensure all audio programs are

closed before plugging in, or unplugging the DG1.

NOTE: when the DG1 is selected as your system's preferred audio

device, no sound will come out of any speakers plugged into your

soundcard. If you wish to use your soundcard instead of the DG1,

either unplug the DG1 from the USB cable, or select your

soundcard as preferred audio device in the Multimedia Properties

control panel for Windows 98, or Sounds and Multimedia control

panel for Windows 2000. It is not possible to use a soundcard and

the DG1 at the same time.

Windows 98

Once Windows 98 starts and the appropriate drivers have been

loaded, the DG1 will automatically be set as your system's preferred

audio device. To verify this, open the Multimedia Control Panel and

make sure that USB Audio Device appears in the Sound Playback

section under Preferred Device. To get to the multimedia control

panel hit Start, then go to Settings, then Control Panel. The

multimedia icon will be in the Control Panel window. Double click

on the icon to open the Multimedia Properties window. In the Audio

tab, under the heading Preferred Device, make sure that USB Audio

Device appears. If it doesn't, use the scroll arrow to the right and

choose USB Audio Device. You're now fully loaded.

Windows 98

Windows 2000