Instruction Manual

81
Return to the Top page
Setting Up
View Camera Control
You can set up display when a CMOS-3xx
Series view camera is used.
1 Press the <MENU> button for 1second.
HOME
DNX7150DAB
DNX715WDAB
Camera view screen appears.
2 Adjust each item as follows.
2
1
1 Guideline
Touching each time turns on or off the
guideline display alternately.
2 Angle
Touching each time changes camera angles in
the following order:
Super wide view/ Wide view/ Overhead view/
Wide view + Top view/ Corner view
For details, see the instruction manual of your
camera.
NOTE
• The video camera controls described above
may not be operable depending the connected
cameras.
• [MENU Key Longer than 1 Second] must be set to
“CAM”. See User interface (P.82)
System Setup
NOTE
• Each operation in this section can be started from
the multi function menu.
1 Press the <MENU> button/
volume knob.
Popup menu appears.
2 Touch [SETUP].
SETUP Menu screen appears.
3 Touch [System].
System Menu screen appears.
See the following section for each setting.
• Set up the user interface (P.82)
• Adjust touch panel (P.83)
• Set up security (P.84)
• Set up memory (P.85)