Instruction Manual
8484
Return to the Top page
Setting Up
Security setup
You can set up a security code to protect
your receiver system against theft.
NOTE
• When the Security Code function is activated, the
code cannot be changed and the function cannot
be released. Note the Security Code can be set as
the 4 digit number of your choice.
1 Touch [Security] in the System Menu
screen.
Security screen appears.
2 Touch [ON] of [SI].
(DNX7150DAB, DNX4150DAB,
DNX4150BT, DNX4150BTR only)
NOTE
• DNX7150DAB
If “SI” is turned on, the SI indicator on the front
panel flashes when the panel is detached. Default
is “ON”.
• DNX4150DAB, DNX4150BT, DNX4150BTR
If “SI” is turned on, the SI indicator on the front
panel flashes when the vehicle ignition is off.
Default is “ON”.
3 Touch [SET] of [Security Code Set].
NOTE
• If you have already completed the code
registration, [CLR] is displayed.
4 Enter a security code with four-digit
number and touch [Enter].
5 Enter the same code again and touch
[Enter].
Security code is registered.
NOTE
• If you enter a different security code, the screen
returns to step 4 (for the first code entry).
• If you have pressed <Reset> button or if you
have disconnected the Receiver from battery,
enter the correct security code as that you have
entered in step 4 and touch [Enter]. You can use
your receiver.