Quick Start Guide

20 ñ English
• Insulate unconnected wires with vinyl tape or other
similar material. To prevent a short circuit, do not
remove the caps on the ends of the unconnected
wires or the terminals.
•
Co
nnect the speaker wires correctly to the terminals to
which they correspond. The unit may be damaged or
fail to work if you share the ¤ wires or ground them to
any metal part in the car.
•
Wh
en only two speakers are being connected to
the system, connect the connectors either to both
the front output terminals or to both the rear output
terminals (do not mix front and rear). For example,
if you connect the ¢ connector of the left speaker
to a front output terminal, do not connect the ¤
connector to a rear output terminal.
•
Af
ter the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
•
Mo
unt the unit so that the mounting angle is 30° or
less.
•
Th
is unit has the cooling fan to decrease the internal
temperature. Do not mount the unit in a place where
the cooling fan of the unit is blocked. Blocking these
openings will inhibit the cooling of the internal
temperature and result in malfunction.
Cooling fan
• Do not press hard on the panel surface when installing
the unit to the vehicle. Otherwise scars, damage, or
failure may result.
• Reception may drop if there are metal objects near
the Bluetooth antenna.
Bluetooth antenna unit
DNX715WDABDNX7150DAB
DNX4
Ñ Supplied accessories
First of all, make sure that all accessories are
supplied with the unit.
1
x1
2
(2 m)
x1
3
[1][2]
x1
4
[3]
x2
5
[3]
x1
6
(3.5 m)
x1
7
x1
8
(3 m)
x1
9
[1]
x1
[1]
DNX7150DAB only
[2]
DNX715WDAB only
[3]
Except DNX715WDAB
Ñ Unit
1) To prevent a short circuit, remove the key from
the ignition and disconnect the ¤ terminal of
the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the wire on the wiring harness.
4) Take Connector B on the wiring harness and
connect it to the speaker connector in your
vehicle.
5) Take Connector A on the wiring harness and
connect it to the external power connector on
your vehicle.
6) Connect the wiring harness connector to the
unit.
7) Install the unit in your car
8) Reconnect the ¤ battery.
9) Press the <Reset> button. (P.4)
10) Perform the Initial Setup.
See First Step (P.6).