Quick Start Guide

22 ñ English
Ñ Microphone unit
1) Check the installation position of the
microphone (accessory 8).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory 8), and stick the microphone to the
place shown below.
4) Wire the microphone cable up to the unit with it
secured at several positions using tape or other
desired method.
5) Adjust the direction of the microphone
(accessory 8) to the driver.
8
Fix a cable with a commercial item of tape.
Ñ Removing the trim plate (DNX7150DAB,
)
1) Engage the catch pins on the extraction key
(accessory4) and remove the two locks on the
lower level.
Lower the trim plate (accessory5) and pull it
forward as shown in the figure.
Lock
Catch
4
5
✎ NOTE
• The trim plate can be removed from the top side
in the same manner.
2) When the lower level is removed, remove the
upper two locations.