Quick Start Guide

English ñ 19
Call using call records
1) Touch [
] (incoming calls), [ ] (missed
calls), or [
] (outgoing calls).
2) Select the phone number from the list.
3) Touch [
].
Call using the phonebook
1) Touch [
].
2) Select the name from the list.
3) Select the number from the list.
4) Touch [
].
Call using the preset number
1) Touch [Preset #] to start calling the
corresponding phone number.
2) Touch [
].
Call by voice
You can make a voice call using the voice
recognition function of the cell-phone.
1) Touch [
].
2) Pronounce the name registered in the cell-
phone.
NOTE
For detailed operation, see Using Hands-Free Unit
(P.75) in the Instruction Manual.
Installation
Ñ Before Installation
Before installation of this unit, please note the
following precautions.
#WARNINGS
If you connect the ignition wire (red) and the
battery wire (yellow) to the car chassis (ground), you
may cause a short circuit, that in turn may start a fire.
Always connect those wires to the power source
running through the fuse box.
Do not cut out the fuse from the ignition wire (red)
and the battery wire (yellow). The power supply
must be connected to the wires via the fuse.
#CAUTION
Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during and
shortly after the use of the unit. Metal part such as
the heat sink and enclosure become hot.
NOTE
Mounting and wiring this product requires skills and
experience. For best safety, leave the mounting and
wiring work to professionals.
Ma
ke sure to ground the unit to a negative 12V DC
power supply.
Do n
ot install the unit in a spot exposed to direct
sunlight or excessive heat or humidity. Also avoid
places with too much dust or the possibility of water
splashing.
Do n
ot use your own screws. Use only the screws
provided. If you use the wrong screws, you could
damage the unit.
If t
he power is not turned ON (“PROTECT” is displayed),
the speaker wire may have a short-circuit or touched
the chassis of the vehicle and the protection function
may have been activated. Therefore, the speaker wire
should be checked.
If y
our car’s ignition does not have an ACC position,
connect the ignition wires to a power source that
can be turned on and off with the ignition key. If you
connect the ignition wire to a power source with a
constant voltage supply, such as with battery wires,
the battery may be drained.
If t
he console has a lid, make sure to install the unit so
that the front panel will not hit the lid when closing
and opening.
If t
he fuse blows, first make sure the wires aren’t
touching to cause a short circuit, then replace the old
fuse with one with the same rating.