Instruction Manual

62 DNX9280BT
Zone Control
You can set the front and rear audio source.
1 Display the Zone Control screen
Touch [
] > [ ] > [Zone Control]. (page 60)
2 Set the Zone Control
[Single Zone] Sets the unit to single zone.
[Dual Zone] Sets the unit to dual zone.
[Front Source] Sets the front audio source.
[Rear Source] Sets the rear audio source.
⁄
• When the rear speaker sound is switched, the audio
source that is output at the AV OUTPUT terminal is
also switched to the same source.
[Rear VOL.] Adjusts the volume of the rear
channel.
⁄
• There are following limitations when zone function is
set to "ON".
- There is no output from the subwoofer and center
speaker.
- "Subwoofer Level", and "Supreme" of <Audio Control>
(page 60) is not available.
- <Equalizer Control> (page 61), <Listening Position>
(page 62), <SRS WOW Control> (page 63), and <Surround
Control> (page 64) are not available.
- <Speaker Setup> (page 65), <Car Type (DTA) Setup>
(page 66), and <Channel Level> (page 67) are not
available.
Listening Position
You can adjust the sound effects according to your
listening position.
1 Display the Position screen
Touch [
] > [ ] > [Position]. (page 60)
2 Set the Position Control
[P1] - [P3] Stores the present adjustment setup
in memory, or recalls it from memory.
To store your adjustment in memory:
Continue to touch [P1] to [P3] more than 2
seconds.
To call your adjustment from memory:
Touch [P1] to [P3] of your adjustment you wish
to recall from memory.
[2], [3] Sets a listening position.
You can select any of "Front R" (Right front),
"Front L" (Left front), "Front All" (All front), "All"
(All), and "User" (User) positions.
[DTA] Displays the Position DTA (Digital Time
Alignment) screen.
3 Exit Position Control
⁄
• The final distance is adjusted to the total of Car Type
Set Up value (page 66) and Position Setup (both Position
and Position DTA) value.
• If you change the Car Type Set Up value (page 66), the
position is set to "All".
• Only the adjusted distance of position setup (Position
and Position DTA values) is stored in memory. Therefore,
the final adjustment distance changes if you change
the Car Type Set Up value (page 66).
Audio Control