Instruction Manual

English
73
Next page 3
Monitor Angle Control
You can adjust the position of the monitor.
1 Display the Angle Setup screen
Touch [
] > [ ] > [Display] > [Angle].
(page 68)
2 Set the Monitor Angle
1
1 Sets the Monitor angle.
[Off Position] Stores the current monitor angle
as the angle during power off.
However, the setting value returns to “0” if you
detach the front panel.
[Auto Open] When turned on, the front panel
is set to open automatically when the ignition
is turned off, so that it can be detached for
antitheft purpose. (
"OFF")
EXT SW Setup
Sets up the exteral switch power mode.
1 Display the EXT SW screen
Touch [
] > [ ] > [System] > [EXT SW].
(page 68)
2 Perform EXT SW Setup
[SW1 Name]/ [SW2 Name] Sets the name of the
external device. See <How To Use the Character
Entry Screen> (page 73) for information on how to
enter a name.
[Output Pattern] Sets the power signal output
mode.
(
EXT SW1: Pulse, EXT SW2: Level)
"Pulse": Generates a single power signal pulse.
"Level": Continues output of high power signal.
Sets to turn output on/off each time the button
on the EXT SW Control screen is touched. See
<External Device Power Supply Control> (page
46).
[Pulse Set] Sets the Pulse signal output time.
Outputs 500ms when "1" is set. Increases by
200ms with each step. Up to 100 steps can be
set.
How To Use the Character Entry Screen
1
1 Enters characters.
[2], [3] Shifts the cursor.
[5], [∞] Switches between key layouts.
[Shift] Toggles between uppercase and
lowercase.
[qwe]/ [abc] Sets the key layout of the character
buttons.
abc : Alphabetical key layout.
qwe : Qwerty key layout.
[Clear] Clears the character.
If you erase a character, locate the cursor on it
and touch this button.
[Space] Enters a space.
⁄
• You can enter characters only after you have applied
the parking brake.