Instruction Manual

84 DNX9280BT
Remote Controller
This unit can be operated using the Remote Controller supplied with this unit.
Battery installation
Use two "AAA"/"R03"-size batteries.
Insert the batteries with the + and – poles aligned
properly, following the illustration inside the case.
⁄
• If the Remote Controller operates only over shorter
distances or does not operate at all, it is possible that
the batteries are depleted. In such instances, replace
the both batteries with new ones.
Remote Controller mode switch
The functions operated from the remote controller
differ depending on the position of the mode
switch.
DVD
T V
NAV
AUD
•
•
•
•
AUD mode
Switch to this mode when controlling a selected
source or tuner source, etc.
DVD mode
Switch to this mode when playing DVDs or CDs etc.
with the player integrated in this unit.
TV mode
Switch to this mode when controlling TV.
NAV mode
Switch to this mode when controlling Navigation
unit.
⁄
• The position of the remote control mode switch is
indicated in the title of each mode, e.g., "(AUD mode)".
• When controlling a player that is not integrated in the
unit, select "AUD" mode.
¤ CAUTION
• Put the Remote Controller in a place where it will not move during braking or other operations. A dangerous
situation could result, if the Remote Controller falls down and gets wedged under the pedals while driving.
• Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat generation may result.
• Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause the battery to
leak fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately rinse with water and consult a
physician.
• Place the battery out of reach of children. In the unlikely event that a child swallows the battery, immediately consult
a physician.