Quick Start Guide

27
English |
Installation
MUTE
P. CONT
ANT CONT
STEERING WHEEL
REMOTE INPUT
REMOTE CONT
REVERSE
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
PRK SW
Connect to the vehicle’s parking
brake detection switch harness.
For best safety, be sure to connect
the parking sensor.
Light Green (Parking sensor wire)
Purple/White (Reverse sensor wire)
Accessory 1
To steering remote
To use the steering wheel remote control feature, you need an
exclusive remote adapter (not supplied) matched to your car.
Connect to vehicle’s reverse lamp harness when using the
optional rear view camera.
Light Blue/Yellow
(Steering remote control wire)
Blue/White
(Power control/ Antenna control wire)
Connect either to the power control terminal when using
the optional power amplifier, or to the power terminal for the
booster amplifier of the film-type or short pole type antenna.
(Max. 300mA, 12V)
DNX8160DABS/ DNX716WDABS/ DNX5160DABS/
DNX516DABS/ DNX5160BTS
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
DNX3160BT : Not used
If no connections are made, do not let the cable
come out from the tab.
Fuse (15A)
Brown (Mute control wire)
A B C
A: Black (Ground wire)
B: Yellow (Battery wire)
C: Red (Ignition wire)
Ñ Wiring harness (Accessory 1) connector
function guide
Pin Color and function
A-4 Yellow Battery
A-5 Blue/White Power Control
A-6 Orange/White Dimmer
A-7 Red Ignition (ACC)
A-8 Black Earth (Ground) Connection
B-1/ B-2 Purple (+) / Purple/Black (–) Rear Right
B-3/ B-4 Gray (+) / Gray/Black (–) Front Right
B-5/ B-6 White (+) / White/Black (–) Front Left
B-7/ B-8 Green (+) / Green/Black (–) Rear Left
• *Speaker Impedance: 4-8 Ω
#WARNING for Connecting the ISO Connector
The pin arrangement for the ISO connectors depends on
the type of vehicle you drive. Make sure to make the proper
connections to prevent damage to the unit. The default
connection for the wiring harness is described in (1) below.
If the ISO connector pins are set as described in (2), make
the connection as illustrated. Please be sure to reconnect
the cable as shown (2) below to install this unit to the
Volkswagen vehicles etc.
(1): Default setting
The red (A-7 pin) of the vehicle’s ISO connector is linked with
the ignition, and the yellow (A-4 pin) is connected to the
constant power supply.
Red (Ignition cable)
Yellow (Battery cable) Yellow (A-4 pin)
Red (A-7 pin)
Unit Vehicle
(2)
The red (A-7 pin) of the vehicle’s ISO connector is connected
to the constant power supply, and the yellow (A-4 pin) is
linked to the ignition.
Red (Ignition cable)
Yellow (Battery cable) Yellow (A-4 pin)
Red (A-7 pin)
Unit Vehicle
Ñ Connecting wires to terminals