Operation Manual

Controlling Audio
69English
3
Set each parameter as follows.
■ [HPF FREQ]
High Pass Filter adjustment. (When Front or
Rear is selected on the Speaker Select screen)
■ [LPF FREQ]
Low Pass Filter adjustment. (When
Subwoofer is selected on the Speaker Select
screen)
■ [Slope]*
1
Set a crossover slope.
■ [Gain]
Adjust the gain of the front speaker, rear
speaker, or subwoofer.
■ [TW Gain] *
2
Adjust the tweeter level. (When Front is
selected on the Speaker Select screen)
■ [Phase Inversion]*
3
Set the phase of subwoofer output.
Check [Phase Inversion] to shift the phase
180 degrees. (When Subwoofer is selected
on the Speaker Select screen)
*
1
Only when “LPF FREQ”/“HPF FREQ” is set to
a mode other than “Through” in [Xover].
*
2
Only when “Tweeter” is set to “Small”,
“Medium”, “Large” in [Speaker Setup].
*
3
Only when “Subwoofer” is set to a mode
other than “None” in [Speaker Setup].
When Speaker network is set to 3 way:
■ [FREQ] (High Pass)
High Pass Filter adjustment.
■ [HPF FREQ], [LPF FREQ] (Band Pass)
Band Pass Filter adjustment. (When mid
range speaker is selected on Speaker Select
screen)
■ [FREQ] (Low Pass)
Low Pass Filter adjustment. (When woofer is
selected on Speaker Select screen)
■ [Slope]*
1
*
2
Sets a crossover slope.
■ [Gain]
Sets gain of each speaker.
■ [Phase Inversion]
Sets the phase of tweeter, mid range, and
woofer output.
Check [Phase Inversion] to shift the phase
180 degrees.
*
1
Only when “LPF FREQ”/“HPF FREQ” (Band
Pass) is set to a mode other than “Through”
in [Xover].
*
2
Only when “FREQ” (Low Pass) is set to a
mode other than “Through” in [Xover].
NOTE
• For how to switch to the 3-way speaker system,
see 3 way speaker system setup (P.67).
Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
!B5A-2484-00_18DNX_M_En.indb 69 2018/02/19 20:35