DVD Player User's Manual

— 33 —
The computer chip in the unit is not functioning normally. Press the reset button on the unit (see p.4).
The disc control mode cannot
be selected.
No wire has been connected to the disc changer input
terminal on the unit.
Connect the wire to the disc changer input terminal on the
unit.
The specified disc does not
play, but another one plays
instead.
The specified CD is quite dirty. Clean the CD.
The CD is upside-down. Load the CD with the labeled side up.
The disc is loaded in a different slot from that specified. Eject the disc magazine and check the number for the
specified disc.
The disc is severely scratched. Try another disc instead.
The sound skips. Something is touching the disc changer. Remove whatever is touching it.
The CD is scratched or dirty. If skipping happens at the same place when the car is
stopped, something with the CD is wrong. Clean the CD.
The display shows that the
changer is being played, but no
sound can be heard.
The specified track will not
play.
Random play or magazine random play has been
selected.
Turn off random play or magazine random play.
There is noise during playback. The MD is soiled with dust or dirt. If another MD is played back and there is no problem, then
the problem is due to the sound quality of the MD itself.
Track repeat, disc repeat, track
scan, disc scan, random play,
and magazine random play
start by themselves.
The setting is not cancelled. The settings for these functions remain on until the setting
to off or the disc ejected, even if the power is turned off or
the source changed.
SOLUTION
POSSIBLE CAUSE
PROBLEM
CD/MD/External disc control mode
CD-R or CD-RW will not play. Disc has not undergone finalisation processing A CD-R or CD-RW cannot be played until it has undergone
finalisation processing on the CD Recorder.
Disc will not play on CD Changer. If your CD Changer does not support CD-Rs or CD-RWs, you
will not be able to play these discs.
The sound skips. The mounting angle exceeds 30°. Adjust to an angle of less than 30°.
The mounting is unstable. Fix the unit securely. When the sound skips at the same
portion even when the car is stopped, the problem lies
with the MD.
The MD loads but soon comes
out again.
Nothing is recorded on the MD. Replace the MD with one that is recorded.
The MD cannot be inserted. There is already an MD loaded. Eject the currently loaded MD and then load the new one.
The MD does not load. The insertion orientation of the MD is incorrect or the MD
is upside down.
Insert the MD in the proper orientation.