Owner's Manual
Precautions
for
Use
mi
Disclaimer
•
Please
note
that
JVCKENWOOD shall
not
be responsible
for
any damages suffered by
the
customer
or
a
third
party
as
a result
of
incorrectly using this product, a
failure
during
use
of
this product,
or
other
trouble,
or
due
to
the
use
of
this product, unless such
liability
is
acknowledged by law.
Copyrights
• Recorded video, image, and
audio
content
cannot be used
for
other
than
personal enjoyment
without
the
consent
of
the
copyright
holder
as
specified in
the
Copyright Act.
•
Please
note
that
the
recording
of
an event
such
as
a show, performance,
or
exhibition
may be restricted even
when
doing
so
for
personal enjoyment.
Precautions
and
notices
Warning I Do
not
operate
the
device
while
driving. Using this
product
does
not
change
the
requirement
for
a
driver
to
take
full
responsibility
for
his
or
her
behavior. This responsibility includes observing all
traffic
rules and
regulations
in
order
to
avoid accidents, personal injury
or
property
damage.
• For
your
own
safety,
do
not
operate
the
controls
of
the
product
while
driving.
• A
window
mount
is
needed when using
the
device in a car. Make sure
that
you place
the
recorder in an
appropriate place,
so
as
not
to
obstruct
the
driver's
view
or
deployment
of
airbags.
• Make sure
that
no
object
is
blocking
the
camera lens and
no
reflective material
is
placed near
the
lens.
Plea
se
keep
the
lens clean.
•
If
the
car's windscreen
is
tinted
with
a coating, this may impact
the
recording quality.
• Connect
the
charger
to
a
proper
power
source. The voltage requirements are
found
on
the
product
case
and/or
packaging.
• Do
not
use
the
charger
if
the
cord becomes damaged.
• Do
not
attempt
to
service
the
unit.
There are
no
serviceable parts inside. Replace
the
unit
if it
is
damaged
or
exposed
to
excess
moisture.
Precautions
for
installation
• Install
the
device
in
a position where
it
will
not
block
the
front
view
of
the
driver {position
where
hidden by
the
rear-view mirror).
• Install
the
device
so
that
it
is
within
the
wiping
range
of
the
wiper.
• Install
the
device
in
a position where
it
will
not
interfere
with
the
movement
of
the
rear-view mirror.
• Take care
not
to
install
the
device
over
the
vehicle inspection sticker
or
other
sticker.
• Take care
not
to
install
the
device
where
it
will
interfere
with
driving
or
airbag operation.
• When installing the device in a vehicle equipped
with
a driving support
system,
check
the
instruction manual
of
the
vehicle and then select an installation position
that
will
not
interfere
with
the driving support system.
•
If
the
device
is
installed incorrectly, event recording
or
parked recording may
not
work
correctly.
• Refer
to
"Installation and Connection"
for
the
loosening
of
fixing
knob, installation orientation, installation
angle, and
other
information
and
then
install
the
device correctly.
• Do
not
install
the
device near a
digital
terrestrial television antenna
or
an electrical component.
• Doing
so
may reduce television receiver sensitivity
or
cause flickering and noise.
• When selecting a position
for
the
suction mount, make sure it's on a
glass
surface
that
is
smooth and free
of
paint.
• Before
mounting,
clean
the
area
with
a dry/clean cloth and add a small
amount
of
moisture
to
the
windshield.
This allows a stronger
bond
to
form
between
the
glass and
the
suction
mount.
•
When
fixing
the
device
with
the
adhesive mount,
use
a commercially available cleaning cloth
or
the
like
to
wipe
off
all
dirt
and grease
on
the
mounting
surface.
If
the
device
is
re-affixed
or
mounted
using,
for
example,
general-purpose double-sided tape,
the
adhesion strength may weaken and
cause
the
device
to
fall.
•
After
mounting
the
device, leave
it
for
24 hours before
use
to
enable
the
mounting
strength
of
the
adhesive
mount
to
improve. Failing
to
do
so
may result
in
the
adhesion
of
the
adhesive
mount
becoming weak and
the
device falling.
•
Fix
the
cord in place
with
tape
or
the
like
so
that
it
does
not
interfere
with
driving.
Precautions
for
use
• Do
not
block
the
camera lens,
get
dirt
on
it,
or
place a reflective object near it.
• When
LED
traffic
lights are recorded, video
in
which
they
appear
to
be flickering
or
flashing may be recorded.
JVCKENWOOD
assumes
no responsibility
with
regard
to
the
distinguishing
or
recording
of
traffic lights.
•
If
coating
is
used
on
the
windshield
of
the
vehicle, recording
quality
may be affected.
There
is
no
guarantee
that
the
device can record video in all conditions.