Owner's Manual

30
[Sensitivity Settings] 1(Low)/2/3(Mid)*/4/5(High)
Set the sensitivity for detecting a vehicle collision while parked.
1: Detects large collisions, 3: Standard, 5: Detects small
collisions
[Exit Time after ACC OFF]
OFF/30 sec*/1 min/3 min
Turn off the ignition key and then set the period of time for
which parking recording is disabled.
[Entry Time before ACC ON]
OFF/30 sec*/1 min/3 min
Set the period of time for which parking recording is disabled
before the ignition key is turned on.
[Parking Recording
Notification]
ON*/OFF
(P.22)
Driving Support Settings
[Forward Collision Warning] ON / ON(Beep Only) / OFF*
(P.18)
[Lane Departure Warning] ON / ON(Beep Only) / OFF* (P.18)
[Departure Delay Warning] ON / ON(Beep Only) / OFF* (P.18)
[Detection Range Settings] Before using the driving support function, adjust the horizon
and bonnet front edge position settings to match the vehicle.
(P.16)
[Mounting Height Settings] 1.2 m*/1.35 m/2 m
Set the mounting height of the device from the road surface.
(P.16)
System Settings
[Time Zone] Set the time zone.
(P.12)
[Daylight Saving Time] OFF*/+1 hr./+30 min
Set daylight saving time. (P.12)
[Time Format] 12-Hour/24-Hour* (P.12)
[Date Format] Month/Day/Year / Day/Month/Year* / Year/Month/Day
Set the format in which the date is displayed. (P.12)
[Notification Volume] Set the notification volume to any of four levels (mute to
maximum). (P.12)
[Select Units] km /h , MPH*
Switch to kilometer or mile display. (P.12)
[System Version] Display the version of the device firmware.
[Update System] Updates the device.(P.31)
[Format SD Card] Formats the SD card.(P.35)
[Factory Reset] Reset the device settings to the factory default state.
DRV-N520W_EN301.indd 30 2017/03/08 14:06