GRAPHIC EQUALIZER G-EQ300 INSTRUCTION MANUAL KENWOOD CORPORATION B60-3538-08 KO (K,P,Y,C,M,X,T) MC 97/12 11 10 9 8 7 6 5 4 3 2 1 96/12 11 10 9 8 7 5
Introduction G-EQ300 (En/K) 2 Before applying power Caution : Read this section carefully to ensure safe operation. Units are designed for operation as follows. U.S.A. and Canada ................................................................................................................................................................ AC 120 V only Australia ...............................................................................................................................................
Introduction G-EQ300 (En/K) Special features 3 Large FL display, 14-band equalizer and 27-spectrum analyzer The large FL display, 14-band equalizer and 27-spectrum analyzer features high visibility of information and make it possible to set EQ (equalizer) curves with high accuracy. MANUAL/REFERENCE modes MANUAL: REFERENCE: PARAMETRIC/GRAPHIC modes PARAMETRIC: GRAPHIC: Five preset patterns have been factory-preset for this mode, too.
IMPORTANT SAFEGUARDS 3Caution : Read this page carefully to ensure safe operation. 4 Please read all of the safety and operating instructions before operating this appliance. Adhere to all warnings on the appliance and in the instruction manual. Follow all the safety and operating instructions. These safety and operating instructions should be retained for future reference. 1.
IMPORTANT SAFEGUARDS 3Caution : Read this page carefully to ensure safe operation. G-EQ300 (En/K) 13.Lightning – For added protection for this appliance during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the appliance due to lightning and power-line surges. 18.
Before operation G-EQ300 (En/K) Unpacking 6 Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost. Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. If your unit was shipped to you directly, notify the shipping company without delay. Only the consignee (the person or company receiving the unit) can file a claim against the carrier for shipping damage.
Names and functions of parts G-EQ300 (En/K) Graphic equalizer display Spectrum analyzer display Character display Character display Frequency display indicator 7 ****** 40 63 98 160 250 400 625 1k 1.5k 2.5k 3.9k 6.3k 10k 16 k EQ. ON MEMORY MANUAL REFERENCE Indicators EQ. ON GRAPHIC MEMORY PARAMETRIC MANUAL F1, F2, F3 REFERENCE WIDE/NARROW GRAPHIC PARAMETRIC F1 F2 F3 WIDE NARROW Display 1 2 3 7 8 4 5 6 PATTERN 9 0 GRAPHIC/ PARAMETRIC TAPE PAUSE WIDE/NARROW EQ.
System connections G-EQ300 (En/K) 8 Make connection as shown below. When connecting the related system components, refer also to the instruction manuals of the related components. 3 Caution: Do not plug in the power lead until all connections are completed. Caution regarding placement Malfunction of microprocessor If operation is not possible or erroneous display appears even though all connections have been made properly, reset the microprocessor referring to “In case of difficulty”.
System connections G-EQ300 (En/K) About the system control connections 9 When this unit is connected to KENWOOD audio component system “SERIES 21”, also connect them through the system control cords to allow system-control operations between components. Connection example AV CONTROL CENTER SYSTEM CONTROL The SERIES 21 components which can be system-connected with this unit include the LD player, MD recorder and DVD player.
Display G-EQ300 (En/K) 10 Preparation ¶Ensure that the MAIN POWER key is set to ON. MAIN POWER -ON –OFF : Keys and control used in the operations described on this page. Switching the display modes 1 Press the ON/STANDBY key to turn the unit ON. ON/STANDBY 2 Select the desired display mode. DISPLAY Each press switches the display modes as follows.
Display G-EQ300 (En/K) Demonstration of equalizer curves can be displayed to help the user understand the features of the equalizer better. 11 : Keys and control used in the operations described on this page. Demonstration method 1 Play a music source. 2 Select the “DEMO” mode. DISPLAY Each press switches the display modes as follows. 1 Graphic equalizer display mode 2 Spectrum analyzer display mode 3 DEMO(Demonstration) mode Demonstration is performed repeatedly in the following order.
Operation of graphic equalizer G-EQ300 (En/K) 12 Five preset patterns have been factory-preset for this mode, too. In this mode, it is also possible to preset (assign) equalizer patterns created by the user in place of the factory presets. : Keys and control used in the operations described on this page. Operation of MANUAL feature 1 Play a music source. 2 Select the “EQ.ON” mode. “EQ.ON” Lights up. EQ.EFFECT EQ. ON 3 Set to “MANUAL“. Each press switches the display as follows.
Operation of graphic equalizer G-EQ300 (En/K) Five exemplary patterns have been preset at the factory. 13 : Keys and control used in the operations described on this page. Operation of REFERENCE feature 1 Play a music source. 2 Select the “EQ.ON” mode. “EQ.ON” Lights up. EQ.EFFECT EQ. ON 3 Set to “REFERENCE”. Each press switches the display as follows. 1 MANUAL 2 REFERENCE MANU./REF. “REFERENCE” Lights up. REFERENCE 4 Select an equalizer pattern.
Operation of graphic equalizer G-EQ300 (En/K) 14 Equalizer pattern list Preset equalizer pattern M1 to M5 (MANUAL) Preset equalizer pattern R1 to R5 (REFERENCE) Pattern can be created and preset by the user in this mode. M1: [Bass intensity] R1: [Mild] For listening a bass sound effect without feeling of sharpness. For listening a mild sound comfortable for ears, like back ground music. 40 63 98 160 250 400 625 1k 1.5k 2.5k 3.9k 6.3k 10k 16 k 40 63 98 160 250 400 625 1k 1.
Creation of desired equalizer patterns G-EQ300 (En/K) Equalizer curves can be created by setting up to 3 center frequencies and the equalizing levels for them. The inclination of each curve can be selected between WIDE (gentle slope) and NARROW (steep). 15 : Keys and control used in the operations described on this page. Operation in PARAMETRIC mode 1 Select the “graphic equalizer display mode”. DISPLAY 2 Select the “EQ.ON” mode. Each press switches the display modes as follows.
Creation of desired equalizer patterns G-EQ300 (En/K) 16 5 Select the center frequency. 98HZ FREQUENCY JOG 6 Adjust the level. EQ.LEVEL 63 98 160 250 400 625 1k ¶Pressing the FLAT key allows to start adjustment from the flat level position. 7 Select the inclination of the curve. WIDE/NARROW Each press switches the display as follows. 1 WIDE : Curve with a gentle slope. 2 NARROW: Curve with a sharp slope. One the two shall light up.
Creation of desired equalizer patterns G-EQ300 (En/K) This mode allows to adjust the equalizer curve for each frequency band provided. The curve created in the parameter mode can be fine-adjusted in this mode. 17 Operation in GRAPHIC mode 1 Select the “graphic equalizer display mode”. DISPLAY Each press switches the display modes as follows. 1 Graphic equalizer display mode 2 Spectrum analyzer display mode 3 DEMO(Demonstration) mode 2 Select the “EQ.ON” mode. “EQ. ON” lights up. EQ.EFFECT EQ.
Creation of desired equalizer patterns G-EQ300 (En/K) 18 Registration of EQUALIZER pattern 1 Create a desired equalizer pattern. See “Creation of desired equalizer patterns“. Any equalizer pattern can be preset if it is being displayed. 2 Preset the equalizer pattern. 1 Press the MEMORY key. 4 3 5 “MEMORY” Lights up. MEMORY 2 Press one of the preset keys. Press while MEMORY is lighted up.
Creation of desired equalizer patterns G-EQ300 (En/K) Through selections of the music genre, tone pattern and purpose of use in three steps, this feature allows to obtain the optimum playback pattern from the 90 equalizer patterns (6 genres × 5 patterns × 3 purposes of use=90). 19 : Keys and control used in the operations described on this page. Operation of GENRE feature 1 Play a music source. 2 Initiate the GENRE mode. PATTERN EQ. ON GRAPHIC MANUAL 40 63 98 160 250 400 625 1k 1.5k 2.
Creation of desired equalizer patterns G-EQ300 (En/K) 20 5 Select the purpose of use of the pattern. The three of the genre keys are also used as the use keys. The display until you select a tone pattern. BYPASS CAR STEREO USE key HEADPHONE STEREO BYPASS CAR H.P.ST. POP./1 ROCK/2 JAZZ/3 FUSION/4 C Major purposes of use provided by the USE keys. When a car stereo or headphone stereo is used, the special curve for use in recording is combined with the displayed curve.
Use of equalizer effect with tape G-EQ300 (En/K) Preparation 21 Make preparation for playback. ● For the preparation for playback, refer to the instruction manuals of the cassette tape deck. : Keys and control used in the operations described on this page. Applying equalizer effect to tape playback 1 Set the TAPE switch to ON. Lights up. TAPE TAPE 2 Select the “EQ.ON” mode. “EQ, ON” Lights up. EQ.EFFECT EQ. ON 3 Create a desired equalizer pattern.
Use of equalizer effect with tape G-EQ300 (En/K) 22 In addition to ordinary recording, special equalizer recording patterns (refer to page 14) can be used for effective playback on car stereo or headphone stereo. Preparation Make preparation for recording. ● For the preparation for recording, refer to the instruction manuals of the cassette tape deck. : Keys and control used in the operations described on this page. Tape recording of sound with equalizer effect 1 Set the TAPE switch to OFF.
Functions of the graphic equalizer G-EQ300 (En/K) 23 Functions of graphic equalizer Book shelf Curtain Compensation for the audio characteristics of the listening room The listening room may contain several objects. Some of them reflect sound and some absorb sound , thus the sound reaching your ears is considerably affected by these objects. In such cases, the graphic equalizer can be used to adjust the frequency response of the room for a flat response from low to high frequencies.
In case of difficulty G-EQ300 (En/K) 24 What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or service representative. Operation to reset The microprocessor may fall into malfunction (impossibility to operate erroneous display, etc.) when the power cord is unplugged while power is ON or due to an external factor.
Specifications 3Caution : Read this page carefully to ensure safe operation. G-EQ300 (En/K) [Audio block] Total harmonic distortion (at 1 kHz, Flat) ................. 0.005% Frequency response ........................... 10 Hz ~ 70 kHz, ± 3 dB Signal to noise ratio (IHF '66) ...................................... 108 dB Graphic equalizer characteristics Adjustment center frequencies ....... 40 Hz, 63 Hz, 98 Hz, 160 Hz, 250 Hz, 400 Hz, 625 Hz, 1 kHz, 1.5 kHz, 2.5 kHz, 3.9 kHz, 6.
G-EQ300 (En/K) 26 For the U.S.A. FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
G-EQ300 (En/K) 27 MEMO :
For your records Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your dealer for information or service on this product.