User's Manual

&211(&7,1*3(5,3+(5$/(48,30(17

$17(11$781(5

Use the ANT 1 and AT connectors to connect an AT-300 external antenna tuner. If you connect the external

antenna tuner to the ANT 2 connector, it will not function.

Note: The AT-300 cannot be used for 50 MHz operation.

TS-590S

AT-300

ANT 1

connector

(The AT-300 Antenna Tuner is

a discontinued model. It may

no longer be available in your

area.)

71&$1'0&3

Use the DATA connector to connect the Audio input/ output lines from a Terminal Node Controller (TNC) for Packet

operation, a Multimode Communications Processor (MCP) for operation on AFSK, Packet, PacTOR, AMTOR,

G-TOR

, PSK31, or FAX, or a Clover interface. Also use the ACC 2 connector to connect SSTV and phone patch

equipment.

• Connect the TNC or MCP to the ACC 2 connector using a cable equipped with a 13-pin DIN plug.

• Connecting the TNC or MCP to a personal computer or dumb terminal requires an RS-232C cable.

• Select LSB or USB mode (it depends on the communication mode) when you operate the MCP/ TNC.

Note: Do not share a single power supply between the transceiver and the TNC or MCP. Keep as wide a separation as possible between

the transceiver and the computer to reduce noise-pickup by the transceiver.

TS-590S

TNC/MCP

Power supply for TNC/ MCP

Personal computer