Owner's manual

71
English
Troubleshooting
Microcomputer mal-
function (the system
does not work, the
display is faulty, etc.).
Malfunctions may occur due to an external cause or because a connec-
z
tion cord was unplugged while the system was turned on.
Use the procedure below to reset the microcomputer.
Symptoms Solution
Resetting the microcomputer
1
Unplug the power cord from the AC
wall outlet.
2
Plug the power cord back in while
holding down the power [
K
] key on
the main unit.
3
Upon the start of the microcomputer
resetting, the display shown on the
right appears.
During the resetting of microcomputer,
z
the display goes out.
4
When fi nish resetting, it turns to
Standby Mode.
Bear in mind that resetting erases any
z
stored information and restores the
system's default settings.
Symptoms Solution Ref. page
Components connected to the D.AUDIO IN terminal
The main unit and
remote control can-
not control a Kenwood
digital audio player.
Connect the player using the dedicated cable PNC-150.
z
Check whether the connected model is compatible.
z
12
44
Symptoms Solution Ref. page
Remote control
The remote control does
not work.
Load new batteries.
z
Use the remote control within its eff ective range.
z
17
17
K-521E_B60-5813-08_01_GVT0294-002A.indb 71K-521E_B60-5813-08_01_GVT0294-002A.indb 71 09.10.26 4:32:02 PM09.10.26 4:32:02 PM