ANIONIC STEREO POWER AMPLIFIER JAG-1021 INSTRUCTION MANUAL KEN WOOD CORPORATION Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the jest performance from your new poor amplifier, For your records Record the serial number found on the bottom of the uniting the spaces designated on the warranty card and in the space provided below.
4 WARNING TO PREVENT ELECTRIC SHOCK, FIRE AND OTHER INJURY. PLEASE NOTE THE FOLLOWINGS: » Tc keep good ventilation, do not anything ® Do not drop pieces of metal, needles, on top of the unit. coins and other electrically conductive materials inch the unit. o The unit is designed to bg connected ® Do not place the unit, where it will and negative grounding. posed to direct sunlight or clods 1o heating device.
* Do nat place the unit in areas of excessive dust, high humidity or on unstable surfaces ® LAC-1021is designed to be professionally installed. The length and nature of your warranty are dramatically affected if you attempt to install it yourself. Skill and experience are required 1o achieve high-end sound, reliability, and appearance in a High-powered auto sound system. If you want to install your own unit, read this booklet completely, research speaker systems and source units extensively.
CAUTION Battery and charging system LAC-1021 amplifier draws enough current to put a substantial additional demand on automotive electrical sterns. When played very loudly, the LAC-1021 may draw 20 to 40 Amperes on the average, with peak demands up to 120 Amperes! A typical stock battery and alternator in good condition wilt handle moderate 1o low average labels, with occasional brief episodes of hard use. However, alternator and battery life will be shortened.
ACCESSORY Number of No.
CONNECTIONS Before making connections Before installing the amplifier, be such to disconnect the wire from the battery’s negative terminal to prevent hazards caused by short-circuiting. e When the amplifier installation and wiring have been completed, first check that they are correct, then set the volume control to the minimum position to prevent speaker damage due to high volume when power is supplied.
B Operations according to system * Moro switch i This switch is used to set the unit’s output system to Normal or Bridged, as described below. LAC-1021 NONOFFICIAL SPRIGGED ROGERED T = Sub woofer system . o Bridled <\ By chatting the switch on te left you can sef the output of this unit for sub woofer output monaural {Sea bellow} splitting, The control on the fight can be used to adjust the sub wafer cut-off frequency.
INSTALLATION 1. Installation Topping screws (#6% 50} { i When making the hole, { do not damage the fuel i tank, brake tube, wiring harnesses, etc. on the other side, i * When installing to tha car, install the unit securely for safety driving. ® Use screws supplied as accessories when installing the unit.
2. Installation location @ Since the parer amplifier has no parts which require operation, it can be installed at position away from the driver’s seat without any hindrances. As generally accepted positions for its installation, places such &s inside the trunk, etc can be considered « Use the extension cables. CA-8 {0.5 m}, CA-18L (1 m), CA-28L (Z m}, CA-48L 14 m), and CA-88L.
TR ‘What often appears to be a malfunction is often due to user error in operation of connect When trouble scours with your unit, please check the following before calling for service. Symptom Cause Remedy Check the speaker cord connections. The sound label is low. (No sound from one SIDS) The sound quality is | 1 bad. {The sound is distorted) 2. A speaker cord has became unconnected. Tre speakers sre connected 1o § 1. Connect each speaker terminal the same 3. 10 its respective speaker outhits.
