Operation Manual

24 English English 25
CONTENTS
Bluetooth Setup
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select [SETTINGS], then press to enter.
3 Turn the volume knob to make a selection, then press to confirm.

See table below for selection.

Repeat step 3 until the desired item is selected/activated.

Press to return to the previous item.
4 Hold to finish the procedure.

To cancel the Bluetooth mode, press .
Item Selectable setting (Preset:*)
PAIRING
DEVICE SEARCH Registers a Bluetooth device (pairing). (For details, see page 22.)
PHONE SELECT Selects a cell-phone connection. (For details, see page 22.)
AUDIO SELECT Selects a Bluetooth audio player connection. (For details, see page 22.)
S-DVC SELECT (For details, see page 22.)
DEVICE DELETE Cancel registration of the Bluetooth device.
1. Turn the volume knob to select the Bluetooth device, then press to confirm.
2. Turn the volume knob to select “YES”, then press to confirm.
DETAILED SET
PIN CODE EDIT Specify the PIN code required when registering this unit using the Bluetooth device. By default, “0000” is
specified.
1. Turn the volume knob to select the number.

To move to the next digit, press ¢ .

To delete the last digit, press 4 .
2. Press the volume knob to register a PIN code
AUTO ANSWER OFF: Does not answer the phone call automatically. ; 0: Automatically answers the phone call at once. ;
1 – 8 * –99: Automatically answers the phone call after lapse of 1 – 99 seconds.
RECONNECT ON *: Automatically reconnects the selected Bluetooth device when radio wave becomes strong enough,
even after it is disconnected. ; OFF: Cancels.

When this function is turned ON, the Bluetooth device is reconnected if it has been disconnected by
selecting [PHONE SELECT]/ [AUDIO SELECT].
BT HF/AUDIO FRONT *: Outputs audio from the front speakers. ; ALL: Outputs audio from the all speakers.
CALL BEEP ON *: Sets whether to output a beep from the speaker when a call comes in. ; OFF: Cancels.
BT F/W UPDATE Display the firmware version and update the firmware.
MIC GAIN 1 — 20 * — 30: Adjust the sensitivity of the microphone for telephone call or adjusts the voice of the caller.
NR LEVEL –1 — 0 * — +1: Reduce the noise generated by the surrounding environment without changing the
built-in microphone volume or adjusts the voice of the caller when it is not clear. Setting to “+” increases the
noise reduction.
EC LEVEL –1 — 0 * — +1: Adjust the level of echo cancellation. Setting to “+” increases the echo cancel reduction.