Owner's Manual
Table Of Contents
- Instruction Manual
- Reset
- Clock Set
- Demo Mode
- Initial Settings
- Table of Contents
- Safety
- Attach / Remove Faceplate
- Parts & Controls
- Getting Started
- Basic Operations
- Listening to the Radio
- Listening to External Components
- Disc / USB Device / iPod
- Hands-Free Phoning
- Bluetooth Setup
- SMS (Short Message Service)
- HD Radio Tuner Control
- Satellite Radio Tuner Control
- Function Settings
- Installation / Connection
- Troubleshooting
- Specs
- Installation / Connection
- Warranty
26 English
Satellite Radio Tuner Control
1 Press SRC to select “SIRIUS” or “XM”.
2 Press BAND repeatedly to select a band
(SR1/ SR2/ SR3/ SR4 ; XM1/ XM2/ XM3/
XM4).
3 Press 4 / ¢ to search for a channel.
■
You need to register to the service provider
to receive the service by Satellite Radio.
Consult the service provider if “CALL … TO
SUBSCRIBE” appears.
■
The radio may take a little time to start
receiving after you select the Satellite Radio
source.
■
If the signal reception fails, “ACQUIRING
SIGNAL”/ “NO SIGNAL” appears.
Category and Channel Search
1 Press to enter Category and Channel
Search mode.
2 Turn the volume knob to select a
category, then press to confirm.
3 Turn the volume knob to select a
channel, then press to confirm.
■
To return to the category select, press .
■
To cancel the Category and Channel Search
mode, press and hold
.
■
Press and hold for about 2 seconds to memorize the current channel.
■
Press briefly to recall memorized channel.
Channel Scan
1 Press and hold to start Channel Scan.
Every receivable channel is checked for 10
seconds.
2 Press to receives the current channel.
Direct Access Tuning using the
remote controller (RC-405)
1 Press DIRECT to enter Direct Access
Tuning mode.
“– – –” appears.
2 Press the number buttons to enter the
channel number.
3 Press 4 / +¢ to search for the
channel.
■
To cancel the Direct Access Tuning mode,
press
.
■
If you make no button operation for 10
seconds, the Direct Access Tuning mode is
automatically canceled.
■
If you cannot receive any signal in the input
Channel due to bad conditions on radio
wave or other such problems, “ACQUIRING
SIGNAL”/ “NO SIGNAL” appears.
Using the remote controller (RC-405)
#FM+ : Selects band.
4 / +¢ : Selects channel.
1 – 6 : Selects preset channel.
Preparation : Only with the optional accessory Satellite radio tuner connected.
B64-4798-1001K.indb26 11/01/0615:07