Owner's Manual
Table Of Contents
- Instruction Manual
- Reset
- Bluetooth PIN (0000)
- Clock Set
- Demo Mode
- Attaching / Removing Faceplate
- Initial Settings
- Table of Contents
- Parts & Controls
- Basic Operation
- Getting Started
- Radio Operation
- CD / USB / iPod / Android Operation
- AUX Input
- Pandora
- iHeartRadio
- SiriusXM (Tuner Required)
- Bluetooth
- Audio Settings
- Display Settings
- Troubleshooting
- Messages
- Specs
- Installation / Connection
- Warranty
ENGLISH
19
BLUETOOTH®
Settings in memory
Store a contact in memory
You can store up to 6 contacts into the number buttons (1 to 6).
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select [
CALL HISTORY
], [
PHONE BOOK
], or
[
NUMBER DIAL
], then press the knob.
3 Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone
number.
4 Press and hold one of the number buttons (1 to 6).
“STORED” appears when the contact is stored.
To erase a contact from the preset memory, select [
NUMBER DIAL
] in step 2
and store a blank number.
Make a call from memory
1
Press to enter Bluetooth mode.
2 Press one of the number buttons (1 to 6).
3 Press the volume knob to call.
“NO MEMORY” appears if there is no contacts stored.
Other settings
1
Press the volume knob to enter
[FUNCTION
].
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow
the instructions stated on the selected item.
4 Press and hold to exit.
To return to the previous setting item, press
.
Default:
XX
BT MODE
PHONE SELECT
Selects the phone or audio device to connect or disconnect.
“
*
” appears in front of the device name when connected.
•
You can only connect a maximum of two Bluetooth phones and one
Bluetooth audio device at any time.
AUDIO SELECT
DEVICE DELETE
1
Turn the volume knob to select a device to delete, then press the
knob.
2
Turn the volume knob to select [
YES
] or [
NO
], then press the knob.
PIN CODE EDIT
(0000)
Changes the PIN code (up to 6 digits).
1
Turn the volume knob to select a number.
2
Press
S
/
T
to move the entry position.
Repeat steps
1
and
2
until you finish entering the PIN code.
3
Press the volume knob to confirm.
RECONNECT ON
:The unit automatically reconnect when the last connected
Bluetooth device is within range.;
OFF
:Cancels.
AUTO PAIRING ON
:The unit automatically pair supported Bluetooth device (iPhone/
iPod touch/ Android device) when it is connected through USB input
terminal.Depending on the operating system of the connected device,
this function may not work. ;
OFF
:Cancels.
INITIALIZE YES
:Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.).;
NO
:Cancels.
JS_KWD_KDC_X700_KW_EN_00_1.indd 19 30/9/2015 4:16:46 PM