KDC-C20V VIDEO CD AUTO CHANGER INSTRUCTION MANUAL VIDEO CD © B64-1953-10 (MW)
Warning / Safety precautions English The marking of products using lasers (Except for some areas) CLASS 1 LASER PRODUCT The label is attached to the chassis/case and says that the component uses laser beams that have been classified as Class 1. It means that the unit is using laser beams that are of a weaker class. There is no danger of hazardous radiation outside the unit.
Stains, scratches, or warping can cause skipping, malfunction, or low sound quality. Take the following precautions to avoid damage to the compact discs. • Avoid touching the recorded side (the side without the titles on) when you hold a compact disc. • The reflective film on a CD-R or a CD-RW is more fragile than that on an ordinary music CD, and may peel off if scratched. Fingerprints on a CD-R or CD-RW are also more likely to cause skipping when the disc is played.
Installation English Use the holes marked ● to install the unit. 2CAUTION Do not tighten the screw B too securely at the time of installation, but tighten it securely after having fixed the bracket A.
■ Vertical installation S 0 Angle adjustment switch position 0 45 45 90 V 90 0 45 90 C 45 90 0 A AUX OFF ON B Ø4 ■ In case of hanging in the trunk Angle adjustment switch position S 0 45 90 0 V 45 45 0 90 90 Ø4 A 0 45 B 90 C 5
Connections O-N switch English "S" 45 0 S O N 0 45 90 V "V" C S T N / L A P D Changer control cable (5m) NTSC / PAL Changer control terminal "NTSC" "PAL" Picture format selector switch F Video cable (4m) Monitor unit (optional) Control unit (optional) EMultiple audio selector switch (5m) 2CAUTION • Do not connect the changer control cable while the control unit is turned ON. • Be sure to press the reset button after installation.
Loading compact discs 4 1 Projection ' ' Make sure the disc magazine is the right way up with the "disc" logo on the top.Pull the tray out by the projection. 2 Insert the magazine into the CD changer until it clicks. 5 ' ' Tray Close the CD changer door. NOTE Place the disc on the tray with the label facing upwards. Insert the tray into the disc magazine until it locks. Check that the discs and trays are inserted properly. The discs are numbered from the bottom from 1 to 10.
English Operation Operate the KDC-C20V using the connected control unit. Operation is the same for the CD changer. (For details, refer to the control unit's disc control/CD changer mode.) NOTE • With some video CD’s, the track number may differ from the jacket display,or may differ from the track number display on the menu screen. • Depending on the disc, unwanted noise may be present in the sound.
Specifications Specifications subject to change without notice. Laser diode ..................................................................................................GaAlAs (λ=780 nm) Digital Filter ..............................................................................................8 Time Over Sampling D/A Converter ............................................................................................................3 Level ∆∑ Spindle speed............................................