KDC-C712 KDC-C662 KDC-C462 COMPACT DISC AUTO CHANGER INSTRUCTION MANUAL © B64-1381-00 (EF)
Safety precautions 2WARNING Take the following precautions to prevent fire and avoid personal injury : • Check that no metal objects (coins, tools, etc.) are left inside the unit to avoid short circuits. • If you smell or see smoke, turn the power off immediately and consult your Kenwood dealer. 2CAUTION Take the following precautions to keep the unit in proper working order. • Do not open the top or bottom cover.
Handling compact discs Stains, scratches, or warping can cause skipping, malfunction, or low sound quality. Take the following precautions to avoid damage to the compact discs. • Avoid touching the recorded side (the side without the titles on) when you hold a compact disc. • Do not stick paper tape, etc. on either stick of the disc. • Do not store discs where they will be exposed to direct sunlight (such as on the seat and dashboard) or high heat.
Loading compact discs ' ' Projection ' 1 Tray 2 3 "EJECT" O-N ' ' 4 5 1. Make sure the disc magazine is the right way up with the "disc" logo on the top.Pull the tray out by the projection. 2. Place the disc on the tray with the label facing upwards. Insert the tray into the disc magazine until it locks. Check that the discs and trays are inserted properly. The discs are numbered from the bottom from 1 to 6 or 10.
Connections Changer control terminal 0 45 90 Control unit (optional) "O" "N" D Changer control cable (5m) O-N 2CAUTION • Do not connect the changer control cable while the control unit is turned ON. • Be sure to press the reset button after installation. • Do not install an antenna of radio equipment or distribute the antenna cable near the changer output cable, for this could cause malfunction with this unit.
Installation ■ Accessories A×1 B×4 C×4 D×1 E×1 F×1 ' ■ Installation Procedure 1 Removing the transportation screws Remove all 3 transportation screws for protecting the internal mechanism before you start to install the unit. Transportation screws NOTE After removing the transport screw, retain it carefully and attach it again before transporting the unit again.
Installation ■ Horizontal installation KDC-C662/C462 0 3 45 C KDC-C712 A 0 45 90 90 3 3 0 45 90 0 45 3 3 0 45 90 3 90 B ø4 3 3 0 45 90 3 Bottom view ■ Vertical installation KDC-C712 KDC-C662/C462 0 3 45 3 45 90 0 C 45 90 3 0 45 A 3 45 3 90 90 0 0 90 3 B 3 3 0 45 ø4 90 3 Bottom view ■ In case of hanging in the trunk 0 3 45 ø4 KDC-C712 KDC-C662/C462 0 45 90 90 3 45 3 0 90 45 3 0 3 A B 90 3 0 45 90 C 3 3 45 3 0 90 Bottom vi
Troubleshooting Guide PROBLEM Sound skips due to vibration. The disc changer mode cannot be selected. POSSIBLE CAUSE SOLUTION • The unit is mounted at a slant. • Changer unit is mounted in an unstable place. • The angle adjustment switches are set improperly. • Mount the unit so that is level. • Mount the unit in a stable place. The O-N selection switch of the disc changer is not set properly. Set the O-N selection switch to "O" position. • Set the angle adjustment switches to the correct positions.
