KDC-HD548U CD-RECEIVER INSTRUCTION MANUAL AMPLI-TUNER LECTEUR DE CD MODE D’EMPLOI REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM MANUAL DE INSTRUCCIONES Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new CD-receiver. For your records Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below.
Safety CONTENTS Safety 2 Preparation 3 How to attach/detach the faceplate How to reset your unit How to prepare the remote controller (RC-405) Basic operations 4 Getting started 6 Canceling the display demonstration Setting the demonstration mode Adjusting the clock Initial settings before operations Listening to HD Radio™ Broadcasts 7 Direct Access Tuning using the remote controller (RC-405) iTunes Tagging Adjust [SETTINGS] mode settings Listening to a disc/ USB device/ iPod 9 Start playing
How to attach/detach the faceplate 1 2 1 How to reset your unit If this unit fails to operate properly, press the reset button. The unit returns to factory settings when the reset button is pressed. Reset button How to prepare the remote controller (RC-405) When you use the remote controller for the first time, pull out the insulation sheet. Insulation sheet 2 Do not expose the faceplate to direct sunlight, excessive heat, or humidity.
Basic operations Loading slot Remote sensor Do not expose to bright sunlight. Volume knob Ejects the disc Display window Detaches the faceplate USB terminal Auxiliary input jack The following indicator lights up when... ATT (blink) : The sound attenuates. (Applicable only when using the remote controller, RC-405). ST : A stereo broadcast is received. HD : HD Radio™ broadcast is tuned in. D : HD Radio digital broadcast is tuned in. MC : HD Radio multicast broadcast is tuned in.
Main unit Remote controller — SRC SRC Volume knob (turn) VOL Volume knob (press) ENT BAND 6( ) 4/¢ SCRL DISP 5/∞ — *AM– / #FM+ ENT + 4/¢ ENGLISH When you press or hold the following button(s)... General operation Turns on. Turns off if pressed and held. Selects the available sources (HD RADIO, USB or iPod, CD, AUX, STANDBY), if the power is turned on. • If the source is ready, playback also starts. “iPod” or “CD” is selectable only when an iPod is connected or a disc is loaded.
Getting started Canceling the display demonstration Adjusting the clock The display demonstration is always turned on unless you cancel it. When you turn on the power (or after you reset the unit), the display shows: [CANCEL DEMO] \ [PRESS] \ [VOLUME KNOB] 1 Press the volume knob. [YES] is selected as the initial setup. 2 Press the volume knob again to confirm. [DEMO OFF] appears.
Selectable setting (Preset: *) CD READ 1 *: Automatically distinguishes between audio file disc and music CD. ; 2: Forces to play as a music CD. No sound can be heard if an audio file disc is played. SP SELECT OFF */ 5/4/ 6 × 9/6/ OEM: Selects the speaker size for optimum performance. ENGLISH Item F/W UP xx.xx YES: Starts upgrading the firmware. ; NO *: Cancels (upgrading is not activated). For details on how to update the firmware, see: www.kenwood.
iTunes Tagging When you hear a song you enjoy on your local HD Radio station, you can tag the song and save the song’s information on this unit. Up to 50 TAGs (song’s information) can be registered to this unit. By using this tagging function, you can easily purchase the songs from Apple iTunes Store. Hold to enter HD Radio tagging mode and tag the song. “TAG” will be indicated on the display when the song information can be registered.
Ejects the disc. (“NO DISC” appears and “IN” indicator goes off.) Press to select track/file. Hold to fast-forwards/reverses. USB terminal Slide open the cover. Press to select next folder. Start playing a disc Connecting a USB device 1 Press SRC to turn on the power. 2 Insert a disc into the loading slot. Playback starts automatically. 3 Press number button 6 ( ) to resume/pause playback (if necessary).
Selecting Repeat Play Press number button 4 (REP) repeatedly to make a selection. Audio CD : TRACK REPEAT, REPEAT OFF AAC/MP3/WMA : FILE REPEAT, FOLDER REPEAT, REPEAT OFF iPod : FILE REPEAT, REPEAT OFF Selecting Random Play Press number button 3 (ALL RDM) repeatedly to make a selection. Audio CD : DISC RANDOM, RANDOM OFF AAC/MP3/WMA/iPod : FOLDER RANDOM, RANDOM OFF Press and hold number button 3 (ALL RDM) to select “ALL RANDOM.” – Applicable only if “RANDOM OFF” is selected initially.
Deleting a song on the playlist 1 Press number button 5 (MEMO MY LIST) to display the playlist. “MY PLAYLIST” appears. 2 Turn the volume knob to select the song you want to delete, then press and hold the volume knob. 3 Turn the volume knob to select “DELETE ONE” or “DELETE ALL,” then press to confirm. Select “DELETE ALL” to delete all the songs in the playlist. 4 Turn the volume knob to select “YES,” then press to confirm. “COMPLETE” appears.
Listening to the other external components Preparation : Make sure [ON1] or [ON2] is selected for [BUILT-IN AUX]. (page 6) 1 Press SRC to select “AUX.” 2 Turn on the external component and start playing. 3 Turn the volume knob to adjust the volume. Auxiliary input jack 3.5 mm (3/16") stereo mini plug (commercially available) Portable audio device (commercially available) Function settings 1 Press the volume knob to enter [FUNCTION] mode.
BASS LEVEL MID LEVEL Selectable setting (Preset: *) –8 — +8 (Preset: 0): Source tone memory: Adjusts the level to memorize in each source. (Before making an adjustment, select the source you want to adjust.) TRE LEVEL BALANCE L15 — R15 (Preset: 0): Adjusts the left and right speaker output balance. FADER R15 — F15 (Preset: 0): Adjusts the rear and front speaker output balance. SUBWOOFER SET ON *: Turns on the subwoofer output. ; OFF: Cancels.
Troubleshooting Symptom Remedy/Cause Sound cannot be heard. Adjust the volume to the optimum level. / Check the cords and connections. “PROTECT” appears and no operations can be done. Check to be sure the terminals of the speaker leads are covered with insulating tape properly, then reset the unit. If “PROTECT” does not disappear, consult your nearest service center. The unit does not work at all. Reset the unit. Radio reception is poor. / Static noise while Connect the antenna firmly.
Remedy/Cause “READING” keeps flashing. Longer readout time is required. Do not use too many hierarchies and folders. Elapsed playing time is not correct. This is caused by how the tracks are recorded. The number of songs contained in “SONGS” Podcast files are not counted in this unit as this unit does not support the category of this unit is different from that playback of podcast files. contained in “SONGS” category of iPod. Correct characters are not displayed (e.g. album name).
About Audio file Playable Audio file: AAC-LC (.m4a), MP3 (.mp3), WMA (.wma) Playable disc media: CD-R/RW/ROM Playable disc file format: ISO 9660 Level 1/2, Joliet, Romeo, Long file name. Playable USB device file system: FAT16, FAT32 Although the audio files are complied with the standards listed above, the play maybe impossible depending on the types or conditions of media or device. About USB device This unit can play AAC/MP3/WMA files stored on a USB mass storage class device.
FM tuner section Frequency range (200 kHz space): 87.9 MHz — 107.9 MHz Usable sensitivity (S/N = 26 dB): 11.2 dBf (1.0 μV/75 Ω) Quieting sensitivity (DIN S/N = 46 dB): 19.2 dBf (2.5 μV/75 Ω) Frequency response (±3 dB): 30 Hz — 15 kHz Signal-to-Noise ratio (MONO): 63 dB Stereo separation (1 kHz): 40 dB USB interface USB standard: USB1.1/ 2.0 (Full speed) Maximum supply current: 500 mA File system: FAT16/ 32 AAC decode: AAC-LC “.
CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product safety. Kenwood Corporation 2967-3, ISHIKAWA-MACHI, HACHIOJI-SHI TOKYO, JAPAN KENWOOD CORP. CERTIFIES THIS EQUIPMENT CONFORMS TO DHHS REGULATIONS N0.21 CFR. 1040. 10, CHAPTER 1, SUBCHAPTER J.
KDC-HD548U Installation Manual Manuel d’installation Manual de instalación GET0696-002A (KW/KN) © 2010 Kenwood Corporation All Rights Reserved. ENGLISH/ FRANÇAIS/ ESPAÑOL Part list: A Faceplate ........................................................................................................... B Escutcheon....................................................................................................... C Mounting sleeve .........................................................................
Basic procedure / Procédure de base / Procedimiento básico 1 Remove the key from the ignition switch, then disconnect the · terminal of the car battery. 2 Make proper input and output wire connections. \ “Wiring connection” 3 Install the unit to your car. \ “Installing the unit” 4 Reconnect the · terminal of the car battery. 5 Reset the unit. 1 Retirez la clé de contact, puis déconnectez la borne · de la batterie de la voiture. 2 Réalisez une connexion correcte des fils d’entrée et sortie. \ “Connexions”
Units purchased lhrough the U,S.A. military exchange service overseas may be serviced under warranty in the continental U.S.A" subjecl to the following conditions. 1) The original warranty is in effect. LIMITATION OF IMPLIED WARRANTIES 2) Proof of purchase is provided to lhe servieer. Any and all implied warranties, including warranlies 01 merchantability and fitness lor aparticular purpose, shall be limited in duralion to the length at this warranty.
KENWOOD USA CORPORATION This warranty will be honored only in Ihe U.sA WHO IS PROTECTED This warranty is enforceable only by the original purchaser KENWOOD LIMITED WARRANTY FOR CAR STEREo COMPONENTS WHAT WE WILL PAY FOR We will pay for all labor and material expenses lor co.. . ered ilems. Payment o! shipping charges is discussed in the next section of this warranty. "'OW LONG IS THE WARRANTY Kenwood U.